Кондиционеры Mitsubishi MSZ-FD50 VA - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
En-3
● OPERATING INSTRUCTIONS ●
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
Before operation:
Insert the power supply plug into the power outlet and/or turn the breaker on.
• Press CLOCK gently using a thin instru-
ment.
Display section
Operation
indicator
lamp
Remote control
receiving section
Emergency
operation
switch
Page 5
Air inlet (back and side)
Piping
Drainage hose
Air outlet
Drain outlet
Remote controller
holder
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Operation display
section
ON/OFF
(operate/stop)
button
Temperature buttons
Page 5
Operation select
button
Page 5
ECONO COOL
button
Page 7
FAN speed
control button
Page 6
Off-timer button
Page 7
On-timer button
Page 7
VANE
control button
Page 6
TIME set buttons
Pages 3, 7
Increase time
Decrease time
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide down
to open
• Install the remote control-
ler holder in a place where
the signal can be received
by the indoor unit.
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to one another, an indoor
unit that is not intended to be operated may respond to the remote controller.
Horizontal vane
Vertical vane
Air outlet
Fan
Air fi lter
Air inlet
Heat
exchanger
Front panel
Plasma
anti-allergy
enzyme fi lter
Fan guard
Outdoor unit
Installing the remote controller batteries
Setting current time
N
AME OF EACH PART
P
REPARATION BEFORE OPERATION
1.
Press CLOCK
3.
Press CLOCK again
2.
Press the TIME buttons to set the
time.
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer)
Indoor unit
Remote controller
Outdoor units may be different in appearance.
Plasma
deodorizing
fi lter
CLEAN button
Page 7
WIDE VANE
button
Page 6
AREA button
Page 4
PLASMA button
Page 7
i-see button
Page 4
i-see sensor
Page 4
Plasma elec-
trode unit
Page 7
Be sure to set the installation position before installing the batteries.
Page 4
1.
Remove the front lid
2.
Insert AAA
alkaline batteries
3.
Install the front lid
4.
Press RESET
