Krups XP320830 - Инструкция по эксплуатации - Страница 5

3

ENGLISH

MAKING ESPRESSO 

IMPORTANT!
If the espresso function is used for the first time, the appliance must be 
cleaned as described in the "FIRST USE" paragraph.

IMPORTANT! To prevent splashes of hot water, check that the filter holder 
has been tightened until it stops before preparing the coffee. Do not 
remove the filter holder while the water is flowing, as the appliance is still 
under pressure.

With ground coffee

The type of coffee you choose will determine the strength and taste of your espresso: the 
finer your ground coffee, the more intense your espresso will be.

„

Fill the water tank with tepid water and refit it on the appliance, making sure that it is 
correctly in place.

Ensure you have removed the red protective cap from under the water tank (1). 

– Remove the water tank 

(A)

 and fill it. The water level should not exceed the "MAX" mark 

on the tank and should contain at least 300 ml (= equivalent to 2 large cups 

(2-3)

. Then 

replace the water tank, ensuring that the cover is closed. 

(4)

. 

– Plug in your machine. 

(5)

. 

– Press the On button 

(C)(6)

. On the control panel 

(D)

, the "On" indicator light switches 

on 

(D2) (7)

. 

– The selection button 

(D.1)

 must be set 

to the espresso position – (button not 

depressed)   (D.1.1) (8)

.

– Place a filter without coffee 

(F1)

 into the filter holder

 (F) (9)

. Slot the filter holder into 

place 

(E)

 and turn it to the right until it stops 

(10)

. Place a receptacle under the filter 

holder 

(11)

. 

– When the espresso preheating indicator light 

(D2.1)

 switches on, turn 

the thumb 

wheel (D.3)

 to the left, to espresso preparation 

(D.3.2) (12-13)

 - The flow will start after 

approximately ten seconds. 

– Let approximately 300 ml of water trickle out (change the receptacle if necessary) 

(14)

, 

then turn 

the thumb wheel

 to position O 

(D.3.1)

 to stop preparation 

(15)

. 

–

IMPORTANT

 / After 25 minutes of disuse, your appliance will switch off automatically 

as a safeguard. 

2.  RINSING THE STEAM SYSTEM 

Remove the water tank and fill it. The water level should not exceed the "MAX" mark on 
the tank and should contain at least 300 ml (= equivalent to 2 large cups). Then replace the 
water tank, ensuring that the cover is closed.

The selection button 

(D.1)

 must be set 

to the steam position (button depressed)

(D.1.2)

(16)

Place the nozzle into a container filled with water 

(G.1) (17)

. 

When the steam preheating indicator light 

(D2.2)

 switches on 

(18)

, turn the thumb wheel 

(D.3)

 to the right, to the steam function 

(D.3.3) (19)

. 

Let the water heat for 20 seconds 

(20)

 then turn the thumb wheel to position O 

(D.3.1)

 to 

stop the steam 

(21)

. Return the selection button 

(D.1)

 to the espresso position 

(D.1.1) (26)

.