Ariete Novecento 1387 - Инструкция по эксплуатации - Страница 16

16

EN

DESCRIPTION OF THE APPLIANCE 

A - 

On/off button

L - 

Power cord

B  -  Control lever

M -  Cup-resting grill

C  -  Boiler temperature thermometer (°C and °F)

N  -  Drip tray

D  -  On indicator lamp

O  -  Thermocream® Filter

E  -  Boiler temperature control lamp

P - 

Perforated silicone disc

F  -  Steam function indicator lamp

Q  -  Thermocream® Disc

G - 

Machine body

R  -  Filter holder

H  -  Water/steam dispensing lever

S  -  Spout for one cup

I  -  Water tank

T  -  Spout for two cups

J - 

Maxi Cappuccino attachment and wand for

U - 

Coffee measure

water and steam supply

V  -  Coffee presser

Identification data

The following machine identification data are shown on the plate found underneath the machine’s standing 

base:

•  manufacturer and CE mark

•  model (Mod.)

•  serial number (SN)

•  electrical supply voltage (V) and frequency (Hz)

•  absorbed electric power (W)

•  assistance toll-free number

Always give the model and serial number to the Authorised Service Centres when requesting assistance.

PRELIMINARY PHASES FOR USE 

Starting the appliance

Check that the voltage of the domestic network is the same as that indicated on the technical information plate 

of the appliance. Place the appliance on a flat surface. 

Wash the tank the first time it is used and fill it with cool tap water up to the level marked “MAX”, then be careful 

to put it back into its seat securely (Fig. 3) following the relevant guide on the bottom of its housing (Fig. 4). 

Make sure that the control lever (B) is in the vertical standby position (Fig. 5). Insert the plug into the socket, 

which must be earthed. 

If water drips out of the pipe inside the tank, this does not mean the machine is faulty but  it is a sign 

that the priming valve is working normally.

Starting the first time

After having filled the tank up to the “MAX” level with cool tap water, start the machine by pressing the button 

(A). The indicator light (D) will switch on indicating that the machine is on. Make at least one cup of water come 

out of the hydraulic circuit of the boiler by pulling the control lever (B) forward and down, Fig. 8, until you see 

water come out of the filter holder coupling seat (Fig. 9). Put the lever back in the vertical standby position.

The indicator light (E) will switch on to indicate that the boiler has reached the right temperature to brew coffee. 

The machine is ready to make coffee.

Warning! 

Remove at least one cup of water from the boiler hydraulic circuit whenever the appliance is turned on 

the first time or after it has not been used for a period of time, by pulling the water/steam dispensing 

lever (H) forward after placing a container under the Maxi Cappuccino device wand (J) Fig. 10. Push 

the dispensing lever back to stop water dispensing.

You will notice that the indicator lamp (E) will turn off, indicating that the boiler has reached the right tempera

-

ture for preparing the beverage.

HOW TO MAKE COFFEE

Put the Thermocream® Disc (Q), the perforated silicone disk (P) and the Thermocream® Filter (O) into the