Ariete 1329/11 Cafe Roma Plus - Инструкция по эксплуатации - Страница 19

18

en

proBLem

Cause

soLutions

Coffee  overflow-

ing from the edges 

of the filter ring.

Probably  an  excess  amount  of 

ground coffee has been placed in 

the  filter  ring  preventing  the  filter 

ring  from  being  correctly  tight-

ened into its housing.  

Slowly remove and disconnect the filter holder because any 

remaining pressure could cause splashes or squirts. Clean the 

coupling seat with a sponge (Fig. 19). Repeat the operation 

placing the correct quantity of coffee in the filter.

Residues  of  ground  coffee  have 

remained  on  the  gasket  of  the 

filter holder coupling seat. 

Clean the seal with a toothpick or a sponge (Fig. 19).

The  hole  of  the  silicone  disc  (V) 

is clogged. 

Wash  the  silicone  disc  (V)  under  running  water,  bending  it 

slightly on the sides in order to free the centre hole of any resi-

due of coffee that could clog it (Fig. 18).

The exit holes of the filter contain-

ing coffee grounds are clogged. 

Slowly remove and disconnect the filter holder because any 

remaining pressure could cause splashes or squirts. Clean 

the clogged filter hole with a pin. Clean the filter using Ariete 

COFFEE CLEAN tabs, following the instructions provided in 

the package. 

the  coffee  is  not 

supplied  or  flows 

too slowly.

The holes of the perforated disc 

in the filter holder coupling seat 

are clogged.

Turn on the machine without the filter holder, making the water 

run. If the water still does not come out from all the holes 

evenly, carry out the descaling cleaning operation using the 

Ariete NOCAL product found at Ariete service centres, follow-

ing the instructions provided in the package.  

The exit holes of the filter contain-

ing coffee grounds are clogged. 

Slowly  remove  and  disconnect  the  filter  holder  because  any 

remaining  pressure  could  cause  splashes  or  squirts.  Clean 

the  clogged  filter  hole  with  a  pin.  Clean  the  filter  using Ariete 

COFFEE  CLEAN  tabs,  following  the  instructions  provided  in 

the package.

The  coffee  blend  is  ground  too 

fine. 

Try using coarser coffee blends.

The coffee blend is pressed down 

too much. 

Tamper coffee inside the filter using less pressure.

The tanks is not inserted well. 

Fit the tank securely by pushing it as far as it will go.

The  hole  of  the  silicone  disc  (V) 

is clogged. 

Wash  the  silicone  disc  (V)  under  running  water,  bending  it 

slightly on the sides in order to free the centre hole of any resi-

due of coffee that could clog it (Fig. 18).

There is little water and the pump 

does not suck it up.

Check that the water level in the tank is correct. If necessary, fill 

it with cool tap water.

the  coffee  is  too 

watery and cold.

The  blend  has  been  ground  too 

coarsely.

A  more  finely  ground  blend  must  be  used  to  obtain  a  more 

concentrated  and  hotter  coffee. Anyhow,  this  problem  is  eas-

ily solved thanks to the Thermocream® System, which always 

guarantees  hot  coffee  accompanied  by  a  reach  cream,  even 

with coarsely ground beans.

Coffee grinder 

jammed.

Impurities are probably mixed 

with the coffee beans.

Press button (8) to stop grinding. Press coffee grinder release 

button (B) and repeatedly turn the container from left to right, 

then try again. If the problem persists, try to set coarser grind-

ing (positions 12-14).