Ariete 1329/11 Cafe Roma Plus - Инструкция по эксплуатации - Страница 18

17

en

Warning!

Do not wash pod filter in a dishwasher.

cleaning the Maxi cappuccino device

Warning!

Perform this operation when the chrome-plated pipe is cold so as to prevent burns. 

Unscrew the device (O) from the small pipe and wash it with running water. The small pipe can be cleaned with a non-abra-

sive cloth. Screw the cappuccino maker back on as far as it will go. If necessary, clean the small steam outlet hole again with 

a pin. After use, always let the steam nozzle run for a few seconds so to free the outlet from any possible residue. 

cleaning the grill and water recovery drawers

remember to empty the water recovery drawers (Q) and (r) from time to time. 

Remove the two drawers from the machine, empty them and wash them under running water. Also wash the cup grill (S).

cleaning the machine body

Warning!

Clean the fixed parts of the machine using only a damp, non-abrasive cloth so as to not damage the body.

cleaning the tank

Periodically clean the inside of the tank with a sponge or damp cloth. 

DecAlcIFIcATIOn

Good maintenance and regular cleaning preserve and keep the machine efficient for a longer amount of time, considerably 

limiting the risks of lime deposits forming inside the appliance. However, should your coffee machine fail to work properly 

as a result of the frequent use of hard, high calcium content water, you may perform a decalcification procedure to restore 

its operational efficiency. For this purpose you must use only Ariete’s, citric acid-based decalcifying products (NOCAL). This 

product  is  easily  found  at  the Ariete  technical  service  centres. Ariete  does  not  assume  any  responsibility  whatsoever  for 

damage to components inside the coffee machine caused by the use of non-compliant products containing chemical addi-

tives. Should you need to decalcify your appliance, please follow the instructions which come with the decalcifying product.

puTTInG OuT OF serVIce

If you want to put the machine out of service, you must disconnect it electrically, empty the water tank and drip tray and clean 

it (see the paragraph on “Cleaning the appliance”).

In the case of scrapping, you must separate the various materials used in making the machine and dispose of them based 

on their composition and on the legal provisions in force in the country of use.

TrOuBleshOOTInG

Warning!

If there are problems with operation, immediately turn off the machine and unplug it from the socket-outlet. 

proBLem

Cause

soLutions

the  coffee  maker 

does  not  supply 

boiling  water  for 

tisanes.

Air  has  probably  entered  the  cir-

cuit and deactivated the pump.

Make sure the tank is properly inserted and that the water is not 

below  the  minimum  level.  Repeat  the  operations  described  in 

the “Preliminary phases for use” paragraph.

The  steam  exit  hole  on  the  dis-

penser wand is clogged. 

Unclog  any  deposits  that  may  have  formed  in  the  hole  of  the 

dispenser wand with a pin. 

the  coffee  maker 

does  not  supply 

steam.

There is little water and the pump 

does not suck it up. 

Check that the water level in the tank is correct. If necessary, fill 

it with cool tap water. 

The  steam  exit  hole  on  the  dis-

penser wand is clogged. 

Unclog  any  deposits  that  may  have  formed  in  the  hole  of  the 

dispenser wand with a pin. 

steam overflow-

ing from the 

edges of the filter 

ring.

You are trying to dispense the 

coffee with the steam function 

on. Check that the steam 

function button has not been 

unintentionally pressed.

Stop dispensing the coffee. Press button (7) to turn off the 

steam function. Wait for the indicator lamp (2) to change from 

blinking to steady before preparing new coffee.