Кофемашина Krups EA895N10 Evidence One - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
38
DRINKS
My machine is not aerating the milk and/or
is not producing any/little froth.
Verify that the block is assembled correctly (including the
connector in the milk tube).
Check that the connector is not blocked or dirty; soak it in a
mixture of warm water and dishwasher liquid, then rinse and
dry before reassembly. (see diagram 88)
Ensure that the steam output is not blocked. If it is, see "The
steam output of your machine appears to be partially or
completely blocked".
Verify that the flexible pipe is not blocked or kinked and that it
is well seated in the One Touch Cappuccino block to avoid any
air leaks. Check that it is properly immersed in the milk.
Rinse and clean the block (see chapters corresponding to the
rinsing and cleaning of the One Touch Cappuccino Block).
For the milk-based preparations, we advise you to use
fresh, pasteurised or UHT milk, recently opened. It is also
recommended to use a cold container.
The milk or the water is not flowing
correctly in the cup or cups.
Check that the One Touch Cappuccino block is correctly
positioned.
The coffee is flowing too slowly.
Turn the “fineness of grinding” button to the right
(J)
to obtain a
coarser ground coffee (depending on the type of coffee used).
Perform one or several rinsing cycles.
Start the cleaning of the machine (see "Automatic cleaning
programme").
Change the Claris Aqua Filter System cartridge (see "Installing
the filter").
Traces of milk are present in an americano
or a hot water.
Perform a milk rinsing, or disassemble and clean the One
Touch Cappuccino block before starting to prepare the drink.
The coffee is too light or not full-bodied
enough.
Avoid the use of oily, caramelised or flavoured coffees.
Check that the bean container contains coffee and that it is
moving down correctly.
Decrease the volume of the preparation and increase the
strength of the preparation using the Aroma+ function.
Turn the “fineness of grinding” button to the left to obtain a
finer ground coffee.
Make your drink in two cycles using the 2-cup function.
The espresso or the coffee is not hot
enough.
Perform a coffee rinsing circuit before you start to make your
coffee.
Increase the temperature of the coffee in the Settings menu.
Heat the cup in the rinsing with hot water before starting to
prepare the drink.
Your tea is not hot enough or is too hot.
Increase or decrease the temperature of the hot water in the
Settings menu.
If one of the problems outlined in the table persists, contact the KRUPS Consumer Service.
Manufacturer:
SAS GSM
Rue Saint-Léonard F-53104 Mayenne
France
