Krups EA890110 Evidence - Инструкция по эксплуатации - Страница 32

The machine asks for the drip 
tray to be emptied although it is 
not full.

The machine is programmed to ask for the drip tray to be emptied after a certain 
number of coffees despite any intermediate emptying operations that you may 
complete.

The appliance asks to be 
unplugged and plugged back in 
again.

Unplug the appliance for 20 seconds, remove the Claris Aqua Filter System 
cartridge if necessary, then plug it back in again.
If the error continues, contact the KRUPS Customer Service team.

The machine does not request 
descaling.

The descaling cycle is requested after the steam circuit has been used a 
significant number of times.

Some ground coffee has found 
its way into the drip tray.

A small amount of ground coffee may settle in the drip tray. The machine is 
designed to evacuate any excess ground coffee so that the percolation zone 
remains clean.

The milk or water is not flowing 
correctly into the cup(s).

Check that the One Touch Cappuccino block is correctly positioned.

There are traces of milk in an 
Americano or a Hot water.

Complete a milk rinsing cycle or dismantle and clean the one touch cappuccino 
accessory before running the preparation. 

There is water underneath the 
appliance.

Before removing the water tank, wait for 15 seconds after the coffee has 
finished flowing so that the appliance finishes its cycle properly. Check that the 
drip tray is correctly positioned on the machine; it should always be in place, 
even when the appliance is not in use. Check that the drip tray is not full.
The drip tray should not be removed during a cycle.

When you turn off the appliance, 
warm water flows out of the 
coffee outlets and the One Touch 
Cappuccino block.

According to the type of recipe prepared, the machine may run an automatic 
rinsing cycle when it is turned off. This cycle lasts only a few seconds and stops 
automatically.

After emptying the coffee 
grounds collector, the warning 
message is still displayed on the 
screen.

Correctly replace the coffee grounds collector and follow the instructions on 
the screen.
Wait at least 5 seconds before replacing them.

The coffee dispenses too slowly.

Turn the ‘fineness of grind’ adjustment dial to the right to make the ground 
coffee coarser (according to the type of coffee used).
Run one or several rinsing cycles.
Run a machine clean (see “Automatic machine cleaning programs p.28).
Change the Claris Aqua Filter System cartridge (see “Installing the filter”) p. 23).

The water tank has been filled, 
but the warning message is still 
displayed on the screen.

Check that the tank is installed correctly on the device.
The float at the bottom of the tank should move freely. Check and unblock the 
float if necessary.

The coffee fineness knob is 
difficult to turn.

Only change the grinder setting when it is running.

The espresso or coffee is not hot 
enough.

Run a coffee circuit rinsing cycle before preparing your coffee. 
Increase the coffee temperature in the Settings menu. Warm the cup by rinsing 
it with hot water before making the drink.

30