Krups EA82FD10 - Инструкция по эксплуатации - Страница 25

Circuit rinsing

Coffee circuit rinsing:

You can start rinsing at any time by pressing 

PROG

 to display the menus then selecting 

MAINTENANCE ► OK ► RINSING 

► OK.

Steam circuit rinsing:

Install the steam nozzle

 (5) 

then place a container beneath the steam nozzle. Select the 

hot water

 recipe on the screen and 

confirm. The cycle will stop automatically after the volume of water indicated on the screen has been flowed through.

It is a good idea to carry out one or more rinses of the two circuits when the appliance has not been used for a number of 

days.

DURING RINSING OPERATIONS, HOT WATER COMES FROM THE NOZZLES. BE CAREFUL NOT TO SCALD YOURSELF.

Preparing the grinder

You can adjust the strength of your coffee by setting the grinding fineness of the coffee beans.

The finer the coffee is ground, the stronger and creamier the coffee will be.

Set the degree of grinding fineness by turning the button “Grinding fineness setting”.

Turning towards the left means finer grinding. Turning towards the right means coarser grinding - 

(13).

YOU MUST ONLY CHANGE THE SETTING DURING GRINDING. 
NEVER FORCE THE GRINDING FINENESS SETTING BUTTON.

PREPARATION OF AN ESPRESSO AND A COFFEE

YOUR APPLIANCE HAS BEEN DESIGNED TO WORK EXCLUSIVELY WITH COFFEE BEANS.

When preparing your first coffee, after a long period of absence or following cleaning or descaling, a little steam and 

hot water will issue from the steam nozzle (self-priming).

Splashing or scalding may occur if the coffee outlet is set too high for the size of your cups.

Preparing an espresso

The quantity of water required for an espresso is between 20 and 70 ml.

Press the   button, wait for pre-heating to end and, if you wish, carry out a rinsing operation.

The drinks selection menu appears 

(14).

Place a cup under the coffee outlet. You can lower or raise the coffee outlet to suit the size of your cup 

(15).

Select your drink with the rotating button and confirm by pressing the confirmation button.

You can set the volume of water at any time with the rotating button.

To stop coffee running into the cup, either press a button or reduce the volume with the rotating button.

Preparing a coffee

The quantity of water required for a coffee is between 80 and 160 ml.

Preparing a long coffee

The quantity of water required for a long coffee is between 120 and 240 ml. The appliance automatically carries out a double 

cycle, so do not remove your cup before preparation is finished.

After grinding, the ground coffee is moistened with a little water. A few moments later, the percolation process begins.

You can adjust the temperature of your coffee.

DO  NOT  REMOVE  THE  TANK  BEFORE  THE  END  OF  THE  CYCLE  (around  15  seconds  after  the  coffee  has  finished 

pouring).

Two-cup function

Your appliance enables you to prepare two coffee or espresso recipes for the following three preparations: espresso/strong 

espresso/coffee. This function is not available for long coffee drinks. The appliance will automatically run two complete coffee 

preparation cycles one after the other. You should therefore ensure that you place the second cup beneath the coffee outlet 

immediately the first cycle has finished.

You have prepared your appliance. The drinks selection menu has appeared 

(14).

23

EN