Кофемашина Siemens TK 911N2 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
24
Visual alert
The fl oat in drip tray
11
or
12
repectively becomes visible.
During the rinsing procedure, when preparing coffee
and drawing steam, a certain amount of water will
collect in the drip trays. As soon as these are full, the
fl oat rises (Fig. 6). Once the fl oat becomes visible, the
corresponding drip tray must be emptied.
● Remove the small drip tray
11
● Pull the large drip tray
12
forwards.
● Remove the capsule container
13
.
● Empty the drip trays and clean them using a little
detergent solution.
● Mount the capsule container
13
on the large drip tray
12
, and push back into position.
● Insert small drip tray
11
.
What if something goes wrong?
The blue illuminated ring
1b
does not light up.
Check the power supply (possible power outage) and
that the ON/OFF switch
17
is set to
I
.
It is impossible to heat water
or generate steam.
Nozzle
10
is blocked up.
Clean nozzle
10
using a detergent solution and a
blunt needle.
Not enough milk froth is being
produced, or it is too runny.
● The frothing attachment
9
is blocked. Wash with a
mild detergent solution, as directed.
● Use cold milk with a fat content of at least 1.5 %.
Message in display
Please fill water
despite a full water tank
After the water tank has been fi lled, no coffee has yet
been served.
Press
g
(hot water).
Water is dripping from the
steam pipe
7
.
● Place a vessel under nozzle
10
.
Press button
g
(hot water), and draw off a little water.
● Finally press
g
once again.
The window
2
opens but will
not close.
● Set the ON/OFF switch
17
to
0
. After approx. 5 sec.,
switch to
I
once more.
● If the window does not move, or opens and fails to
close properly, it can be carefully slid shut by hand.
During the descaling
procedure, no liquid runs
out out of nozzle
10
into the
collecting vessel.
● Break off the descaling procedure with the button
a
(Stand by). Remove the nozzle
10
and the adapter
8
,
and clean them thoroughly (scale residue). Refi t both
parts and repeat the descaling procedure from the
start as directed.
en
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
