Кофемашина Bosch TES 50129 RW - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Robert Bosch Hausgeräte GmbH
10
en
4. Lift the water tank lid (17).
5. Remove and rinse the water tank (16)
and fill it with fresh cold water. Do not fill
above the
max
mark.
6. Replace the water tank (16) and push it
firmly downwards into place.
7. Close the water tank lid (17).
8. Fill the bean container (1) with coffee
beans (for preparation using ground
coffee see „Preparation using ground
coffee“ on page 13).
9. Press the power on/off switch
O / I
(9) to
switch on the appliance. LED
D
flashes
and LED
F
lights up.
10. Place a container under the milk frother
outlet (6).
11. Carefully pull out the milk frother (6)
to open it. The appliance rinses out
the milk frother (6) with water. LED
F
flashes.
12. When LED
F
lights up constantly,
press in the milk frother (6) to close it.
The appliance heats up and rinses. Some
water will run out of the coffee outlet. When
buttons
A
(12),
B
(11) and
C
(10) light
up, the appliance is ready for use.
Switching off the appliance
If the appliance has not been used for
an hour, it rinses automatically and then
switches off (the length of time can be ad-
justed, see “Settings”, “Automatic switch-off”
on page 11).
Exception:
The appliance switches off with-
out rinsing if only hot water or steam was
dispensed.
To switch the appliance off manually before
this, press the service button (12). The ap-
pliance rinses and switches off.
Note:
If the appliance is being used for the
first time, the service programme has been
run, or the appliance has not been oper-
ated for a long period, the first beverage will
not have the full aroma and should not be
consumed.
When the fully automatic espresso machine
is first used, you will achieve a suitably thick
and stable “crema” only after the first few
cups have been dispensed.
If the appliance is in use for a long period of
time, water droplets will form on the ventila-
tion slits. This is normal.
Water filter
Using a water filter can prevent a build-up
of limescale deposits.
A new water filter must be rinsed before it
can be used. To do this, proceed as follows:
1. Press the water filter firmly into the emp-
ty water tank with the aid of the measur-
ing spoon (18).
2. Fill the water tank (16) with water up to
the
max
mark.
3. Turn the rotary
knob (13) to position
4. Press and hold buttons
B
(11) and
A
(12) simultaneously for at least
5 seconds. Either
“off” or
“on”
lights up.
5. Press the start button (10) to select “on”.
6. Press and hold the start button (10) for
at least 5 seconds to confirm. All of the
LEDs light up briefly.
7. LED
D
flashes and LED
F
lights up.
8. Place a container with a capacity of 0.5
litres under the milk frother outlet (6).
9. Pull out the milk frother (6) to open it.
LED
F
flashes.
10. Water will now flow through the filter and
rinse it.
11. When LED
F
lights up constantly,
press in the milk frother (6) to close it.
12. Empty the container.
The appliance is ready to use again.
TES501_Heft1_RW.indb 10
14.09.2011 16:10:24
