Smeg FAB50X - Инструкция по эксплуатации - Страница 20

44

User instructions

PROBLEM

POSSIBLE CAUSE

PROBABLE SOLUTION

Too much ice forming in freezer

- inside 

temperature 

setting

thermostat set on too low a

temperature;

-  Use the regulator to set a lower

cooling temperature to increase

the temperature inside the

appliance slightly;

- check that the gaskets are

providing an airtight seal: If they

are cracked, try to soften the

gasket by pulling it with one hand

and sliding your fingers (held

together - no gaps between them)

along the inside;

-  open the door less frequently and

for less time;

- 

increase the atmospheric

temperature and humidity;

-  do not put hot food or drinks in the

freezer;

The front of the appliance is warm to

the touch

- 

- the refrigerator is operating

normally. There is a surface

heating system inside the cabinet

to limit the formation of

condensation around the door

seal.

Doors out of alignment:

-  check that the floor under the

refrigerator is level,and also adjust

the two rear feet if necessary.

Check whether changing the

settings of the two feet improves

the alignment.

CUSTOMER SUPPORT SERVICE – READING THE IDENTIFICATION PLATE.

IF YOU HAVE PROBLEMS WITH THE PRODUCT THAT YOU HAVE PURCHASED WHICH ARE NOT COVERED
BY THE TABLE ABOVE AND YOU NEED FURTHER CLARIFICATION, YOU CAN CONTACT OUR
AUTHORISED TECHNICAL SUPPORT SERVICE. YOU WILL FIND THE ADDRESS AND TELEPHONE NUMBER
IN THE PHONE BOOK FOR YOUR AREA UNDER 

SMEG

.

TO SPEED UP THE SERVICE, PLEASE BE READY TO INFORM OUR CALL SERVICE OPERATORS OF THE
MODEL OF THE PRODUCT YOU HAVE PURCHASED AND THE SERIAL NUMBER MARKED ON THE
NAMEPLATE INSIDE THE BODY OF THE REFRIGERATOR. THANK YOU IN ADVANCE FOR YOUR
COOPERATION.