SIEMENS KG49NSW2AR - Инструкция по эксплуатации - Страница 22

en

22

Fault

Possible cause

Remedial action

Appliance is not cooling, 

temperature display and light 

are lit.

Showroom mode is switched 

on.

Press and hold compartment button and 

A

 setting button for 5 seconds until an 

acknowledgement signal sounds. Another 

acknowledgement signal sounds when the 

buttons are released.
After a short time check whether your 

appliance is cooling.

The side panels of the 

appliance are warm.

Pipes run into the side panels 

which heat during the 

cooling process.

That is normal behaviour for the appliance and 

not a fault.
Furniture touching the appliance will not be 

damaged by the heat.

Freezer compartment door 

was open for a long time; 

temperature is no longer 

reached.

The evaporator (refrigeration 

generator) in the 

NoFrost system is covered 

in thick ice and can no 

longer be defrosted fully 

automatically.

To defrost the evaporator, remove the frozen 

food with the compartments, insulate well 

and store in a cool location.
Switch off the appliance and move it away 

from the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins 

to run into the evaporation pan, 

at the rear of the appliance.
To prevent the evaporation pan 

from overflowing in this case, 

mop up the condensation with a sponge.
The evaporator is defrosted when the water 

stops running into the evaporation pan. Clean 

the interior. Switch the appliance 

back on again.