Maunfeld MBF.177BFW - Инструкция по эксплуатации - Страница 27

1131

27

Cleaning - Electrical connection

1

3

2

V

R

EN

CLEANING

Before starting any cleaning, disconnect the 

appliance from the mains electricity supply.
 

The protections (wire grill, covers) must not be 

removed by unqualified personnel: do not use the 

appliance if the protections have been removed.

WHEN CLEANING THE INTERNAL PLASTIC PARTS AND 

THE DOOR GASKEt:

do not use abrasives or detergents of any kind.

-  Use a warm solution of bicarbonate of soda (two 

spoonfuls in two litres of water).

CLEANING THE CONDENSER

-  This should be carried out at least twice a year.
-  Clean using a domestic vacuum cleaner or a brush. 

A dirty condenser will have a negative effect on the 

appliance and reduce its performance.

FOR PROLONGED ABSENCES

-  Empty the compartments.
-  Disconnect the appliance from the mains electricity 

supply.

-  Clean both the compartments and dry them.
-  Leave the doors open to prevent bad smells or mould 

from forming.

CLEANING THE WATER DRAIN

When cleaning the condenser, check that the rear drain 

pipe  R  is not blocked.

-  Remove drain pipe R from the container V and if 

necessary clean it.

CLEANING THE ANTIBACTERIAL FILTER
-  Every 4 months.

1  Remove the filter-holder cover fig. 1.

2  Remove the filter fig. 2.

3   Wash it with hot water (it can be washed also in the 

dishwasher); dry it at a temperature lower than 100°C; 

to maintain a proper filtering capacity, replace the filter 

every 2 years. Remount it in the specific seat and place 

back the cover fig1.

POWER SUPPLY CABLE

-  Periodically inspect the power cable to check its 

condition.

-  If the cable is damaged, do not use the appliance and 

do not attempt any repairs. Call a qualified technician 

to replace the faulty cable.

ELECTRICAL CONNECTION

Check that the mains voltage complies with that indicated on 
the rating plate located on the bottom left of the compartment. 
If the mains socket does not have an earth connection or if 
the plug is not suitable for the mains supply system, refer to 
a qualified electrician. Do not use adapters or extension leads, 
as these may overheat and burn.