Viking VBI7360WRAB - Инструкция по эксплуатации - Страница 13

13

P

roduc

t C
a

re

Cleaning & Maintenance

 Glass  Shelves

  To clean your refrigerator’s glass shelves, lift the shelf out by lifting the 
front and releasing the hooks from the metal track. Then pull the shelf 
out. Be sure to allow the glass shelves to adjust to room temperature 
before cleaning.  Use a mild detergent with water to clean.  Dry glass 
shelf thoroughly and replace shelf by inserting hooks into metal track 
and lowering front.  

Door Gaskets

Clean the door gaskets every three months using the same procedures used for interior surfaces. You should apply a light fi lm of 
petroleum jelly to keep gaskets pliable.

CAUTION

 To avoid personal injury or property damage, handle 
tempered glass shelves carefully. Shelves may break suddenly 
if nicked, scratched, or exposed to sudden temperature 
change.  

Condenser Cleaning Indicator

The refrigerator temperature display will be blinking “CL” to indicate that it is time to clean the condenser coil. 

Condenser Cleaning:

There is always chance of getting the condenser clogged due to dust in the air, pet hair, etc. We recommend cleaning the condenser 
once every 6 months. It is always better to clean the condenser coil as soon as you perform any construction activities, or work that 
produce lots of dusts near the unit.

To clean the condenser:
1.  

Turn 

off  the main power switch located at the top of unit behind the top access panel as shown in Settings and Functions – Power 

On/Off  switch page 6.

6.  Replace the access panel and kick plate.
7.  Turn main power switch on. Replace top access panel.
8.   Reset and remove the “CL” from the temperature display by simultaneously pressing the up and down arrow key for 3 seconds. 

2.   Remove the bottom freezer drawer by pulling all 

the way out, removing the rear clips and lifting 
out. Details are shown in the freezer section page 
10.

3.   Remove the kick plate by loosening two screws and slide out 

though the key hole

4.   Remove the access panel by removing 2 

screws as shown here and pull out with force 
to unsnap the panel

5.   Vacuum the front surface of the condenser coil using any house hold 

vacuum cleaner extension. It is recommended to vacuum the coil 
rather than using any duster. Duster may damage the fi n. Make sure to 
remove the dust completely out of the coil area.