De Dietrich DRS1204J - Инструкция по эксплуатации - Страница 19

285690

Fault:

Cause/Remedy

The appliance does not 
operate after connection to the 
mains:

 • Check if there is power in the socket and if the appliance is
   switched on.

Cooling system operates 
continuously without 
intermittent stoppages:

 • Ambient temperature too high.
 • Frequent opening of the door, door open too long.
 • Door not closed properly (particle between door gasket, sagged  
   door, check gasket sealing, etc...).
 • Excessive quantity of fresh food inserted at once.
 • Refrigerator probe (A) is clogged with fresh food. Relocate the
   food to provide air circulation around the probe (certain models
   only).
 • Check air circulation for suf

fi

 cient cooling of the compressor, and

   clean the condenser.

Excessive ice formation at the 
rear interior wall of the freezer:

 • Frequent opening of the door, door open too long.
 • Inserting hot food in the freezer.
 • Food or dish is touching the rear interior panel of the refrigerator.
 • Bad door sealing; clean or replace the gasket if dirty or damaged.

Water dripping from the 
appliance:

 • Drain outlet is clogged, drain water drips past the collection
   groove.
 • Clean the clogged outlet using plastic straw.
 • Thaw thick ice deposits manually (see chapter Defrosting). 

Bulb replacement:

 • Before replacing the light bulb, disconnect the appliance form the
   power supply (pull the power cord from the wall socket). 
   B – Insert the screwdriver into the cover slot, lift it and remove the 

cover. 

   Replace the bulb with the equivalent new bulb (E 14, same 

voltage as the original one) and replace the cover back to its 
position.

 • Don’t forget: the old bulb does not belong to organic waste.
 • Light bulb is consumption material and is not covered by the 

warranty!

Helpful hints

 • If none of the above proves effective and you can not remove
   the fault yourself, disconnect the appliance from the mains ( see
   chapter regarding the ON/OFF function), pull the power cord from
   the wall socket, wait for approximately 10 minutes and reconnect
   the appliance.
   If the fault persists call the nearest service center and tell them
   the information from the rating plate: type of appliance, model and
   serial number, located inside the appliance.

19

Troubleshooting guide