Sharp SJXG60PGRD - Инструкция по эксплуатации - Страница 26

EN-11

Follow the tips below to prevent cracks on the 

inner surfaces and plastic components

• Wipe out food oil adhered to plastic parts.

• 

Some household chemicals may cause damage, so 

use only diluted washing-up liquid (soapy water).

• 

If undiluted detergent is used or soapy water is not 

wiped off thoroughly, it may result in cracks of plastic 

parts.

If the refrigerator needs to be switched off for an 

extended period, the following steps should be taken to 

reduce the growth of mold

1. Remove all food.

2. Remove the power plug from the socket.

3. Clean and dry the interior thoroughly.

4. Keep all the doors open slightly for a few days to dry.

Care and cleaning

Note

• 

Do not use heavy-duty cleansers or solvents (lacquer, 

paint, polishing powder, benzine, boiled water, etc.) 

which may cause damages.

• 

If you pull out the power plug once, wait 5 minutes at 

least before connecting the power plug again.

• 

The glass shelves weigh approximately 3 kg each. 

Hold them firmly when remove from the cabinet and 

carry.

• Do not drop objects inside the refrigerator or strike the 

inner wall. This may cause cracks to inner surface.

• 

Remove the accessories (e.g. shelves) from the 

cabinet and the door. Wash them by warm soapy 

dishwashing water. After that, rinse them in clean 

water and dry. (Only fruit and vegetable shelf is not 

removable)

• 

Clean the inside with a cloth soaked in warm soapy 

dishwashing water. Then, use cold water to wipe off 

soapy water thoroughly.

• 

Wipe the exterior with a soft cloth each time it gets 

dirty.

• 

Clean the magnetic door seal with a toothbrush and 

warm soapy dishwashing water.

• 

Wipe the control panel with a dry cloth.

<SJ-XG55PM,SJ-XG60PM>

Evaporating pan

Before transporting

Cleaning

Important

Defrosting of the  

cooling unit

When the compartment 

light is blown

Switching off your  

refrigerator

Wipe up water in the evaporating pan. Before wiping 

up the water, wait more than 1 hour after pulling out the 

plug because refrigeration cycle equipment is extremely 

hot. (The evaporating pan is located on the rear of the 

product.)

Defrosting is automatically operated by a unique energy 

saving system. (Approx. once a day.) Ice making takes 

time because the temperature inside becomes slightly 

higher than usual during the defrosting.

Contact the service agent approved by SHARP to 

replace the light. The light is not to be replaced other 

than by qualified service personnel.