Gorenje RK6355W(1) - Инструкция по эксплуатации - Страница 12

Instructions for Use

12

Cleaning the Appliance

Disconnect the power supply before
cleaning the appliance.

Do not use coarse or aggressive cleaning
agents as you can damage the surface. Be
careful to remove any cleanser agent
remaining after cleaning.



Clean the 

exterior

 with water and detergent.



Varnished surfaces are cleaned with soft
cloth and an alcohol based cleaning agent
(for example glass cleaners). You may also
use alcohol (ethanol or isoprophylic alcohol).



The application of abrasive and specially
aggressive cleaners, such as the stainless
steel cleaners, is not appropriate for the
cleaning of plastic and coated parts.



Remove the 

detachable accesories 

in the

interior of the appliance and clean it with
water and liquid detergent. Plastic parts
cannot be washed in washing machine.



Wash the 

interior 

of the appliance with

lukewarm water, in which you added one or
two spoonfuls of vinegar.



Every now and then wipe the 

condenser

 on

the rear wall. Use soft non-metal brush or
vacuum cleaner.



Do not forget to clean also the defrost water

receptacle

 above the refrigerator

compressor (do not remove the receptacle).

After cleaning, connect the appliance to power
supply and reload it.

Switch Off the Appliance When Not In
Use

If you do not intend to use the appliance for a
longer period, set the thermostat knob to the

STOP (0)

 position, disconnect the power

supply, take out the foods and defrost and
clean the appliance. Leave the door slightly
open.

 Trouble-Shooting Guide

During the service, you can come across some
troubles that in most cases result from
improper handling of the appliance and can
easy be eliminated.

The Appliance Fails to Operate After
Connecting to the Mains Supply



Check the supply in the outlet socket and
make sure the appliance is switched on
(thermostat knob in operating position).

Continuous Operation of the Cooling
System



The door was frequently opened or it was left
opened for too long.



The door is not properly closed (the door
may sag, the gasket may be polluted or
damaged).



Perhaps you have overloaded the appliance
with fresh foods.



The reason may be inadequate ventilation of
the compressor and condenser (assure
adequate air circulation and wipe off the
condenser).

Ice Formation on the Inner Rear Wall

As long as the defrost water runs to the
channel and through the outlet to the drain pan
on the compressor, automatic defrosting of the
appliance is assured.
In case the ice formation on the inner back wall
is increased (3-5 mm), ice should be manually
defrosted.
Set the thermostat knob to 

STOP (0)

 position

and leave the door open. Never use electric
devices for defrosting and do not scrape the
ice or frost layer with sharp objects.
After completed defrosting, turn the knob to
desired position and close the refrigerator door.
The cause of increased ice formation may be
one of the following: