Ryobi RY18LMH37A-250 5133004583 - Инструкция по эксплуатации - Страница 6

■

Do not tilt the product when turning on 

the motor or while the motor is running. If 

absolutely necessary, you may raise the 

front of the lawnmower by no more than 5 

cm to enable easier starting. Press down 

on the handlebar to achieve this. Always 

return the lawnmower to its normal position 

with all wheels on the ground before cutting. 

Tilting the lawnmower exposes the blade 

and increases the probability of objects 

being thrown and accidental contact with 

the blade.

■

Turn on the motor carefully according to 

instructions and keep hands and feet away 

from blades. Do not put hands or feet near 

or under rotating parts.

■

Never pick up or carry the product while it 

is running. 

■

Turn off the product, remove the isolator 

key and the battery pack, or disconnect 

the product from the power supply. Make 

sure that all moving parts have come to a 

complete stop:

●

whenever leaving the product 

unattended (including disposal of grass 

clippings)

●

before clearing blockages or unclogging 

discharge chute

●

before checking, cleaning, or working on 

the product

●

before removing the grass catcher or 

opening the grass discharge chute cover

●

after striking a foreign object; inspect the 

product for damage and make repairs 

as necessary before restarting and 

operating the product

●

If the product starts to vibrate abnormally 

(check immediately)

–

inspect for damage, particularly the 

blades

–

replace or repair any damaged parts

–

check for and tighten any loose parts

■

Avoid holes, ruts, bumps, rocks, property 

stakes, or other hidden objects. Uneven 

terrain could cause a slip-and-fall accident.

■

Always ensure that the motor control cable is 

never trapped, pinched or otherwise damaged 

during assembly or when folding the handle.

ADDITIONAL BATTERY SAFETY 

WARNINGS

 WARNING

To reduce the risk of 

fi

 re, personal injury, 

and product damage due to a short circuit, 

never immerse your tool, battery pack or 

charger in 

fl

 uid or allow a 

fl

 uid to 

fl

 ow inside 

them. Corrosive or conductive 

fl

 uids,  such 

as seawater, certain industrial chemicals, 

and bleach or bleach-containing products, 

etc., can cause a short circuit.

PRODUCT FEATURES

OVERLOAD PROTECTION AND 

OVERHEAT PROTECTION

The product has an overload protection 

device. When overloading is detected, the 

product will automatically turn off.
For both AC and battery mode of operation, 

do the following steps if the product stops 

working: 
1.  Release the on/off levers for a few sec-

onds, and let the product cool down for a 

few minutes. 

2.  Follow normal switch on procedure to 

activate the lawnmower again.

3.  If the product still does not turn on, 

reinstall the battery pack (battery mode 

only).

If the protection device operates often, raise 

the height of the cut, and check that the blade 

is not damaged. If it still occurs, bring the 

product to an authorised service centre for 

investigation.
The battery pack has overheat protection. 

Excessive temperatures will cause the battery 

to stop powering the product. If the battery 

pack is too warm, allow it to cool down before 

resuming operation. If the product still does 

not work, recharge the battery.

NOTE:

 The battery pack LED indicator will 

not work if the battery protection feature has 

caused the battery pack to stop powering 

the product. Turn off the product or remove 

the battery pack from the product and the 

battery pack LED indicator will resume normal 

function.

4

| English