OREGON LM400 609479 - Инструкция по эксплуатации - Страница 16

16

Lawnmower Model LM400

Troubleshooting

Troubleshooting

Troubleshooting

Use this table to see possible solutions for possible problems with the lawnmower  If these suggestions 

do not solve the problem, see “Warranty and Service” 

SYMPTOM

POSSIBLE CAUSE

RECOMMENDED ACTIONS

Tool fails to operate

Possible clogging

Remove battery, remove safety key  
Clear obstructions  
Check underneath the garden product and clear out as 
necessary (always wear gardening gloves) 

Battery not fully charged

Charge battery 

Battery not inserted 
(properly)

Properly insert battery 

Grass too long

Increase height of cut and tilt garden product to reduce 
starting load 

Motor protector has 
activated

Allow motor to cool and increase height of cut 

Safety key pointing 
towards a discharge 
battery

Check if the safety key points towards a charged 
battery 

Battery too hot/cold

Allow to cool/warm 

Safety key not inserted 
correctly/fully

Insert safety key correctly 

There is a short delay in 
the motor starting after 
engaging the safety 
button switch

Hold safety button for 1 – 3 seconds before engaging 
switch lever to start motor 

Motor starts and 

stops immediately

Battery not fully charged

Charge battery 

Isolator key not inserted 
correctly/fully

Insert safety key correctly 

Battery not inserted 
(properly)

Properly insert battery 

Battery too hot/cold

Allow to cool/warm 

Tool functions 

intermittently

Internal wiring of garden 
product damaged

Contact service agent 

Motor protector has 
activated

Allow motor to cool and increase height of cut