Husqvarna LC141C 9670993-01 - Инструкция по эксплуатации - Страница 119

LED display

Possible faults

Possible action

Error LED flashes

Battery discharged

Charge the battery. See 

To charge the battery on page

113.

Temperature deviation

Use the battery in surroundings where temperatures are

between -10°C and 40°C.

Over voltage

Check that the mains voltage corresponds with that sta-

ted on the rating plate on the product.

Remove the battery from the battery charger. Wait 5 se-

conds and try again to recharge the battery. If the pro-

blem persists, contact an authorised service agent.

Error LED is lit

Cell difference too much (1V)

Contact an authorised service agent.

Battery charger

LED display

Possible faults

Possible action

Error LED flashes

Temperature deviation

Use the battery charger in surroundings where tempera-

tures are between 5°C and 40°C.

Error LED is lit

Contact an authorised service agent

Control panel

Keypad

Possible faults

Possible action

Error LED flashes

Overload

Increase cutting height. See 

To set the cutting height on

page 112.

If motor speed drops below a cri-

tical value, the motor will stop.

Motor control has overheated

Switch off the motor and wait until the motor has cooled

down.

Blade blocked.

Prevent unintentional start by turning the safety key to

”0”, removing the battery and waiting at least 5 seconds.

Make sure the blade can rotate freely. If the problem per-

sists, contact an authorised service agent

Battery error or no signal from

battery

Check that the battery is inserted properly and examine

the battery connector. If error LED flashes on the battery,

refer to the troubleshooting for battery. See 

Battery on

page 118.

Machine deactivates

Battery discharged

Charge the battery. See 

To charge the battery on page

113.

Battery connector failure

Examine battery connector

71 - 001 - 03.11.2016

119