Газонокосилки Husqvarna LC141C 9670993-01 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Operation
Introduction
WARNING! Before you operate the product,
you must read and understand the safety
chapter.
To set the mower in operation position
If the handle has been folded to transport and storage
position (see
To set the product in transport position on
page 120), follow these steps to return the handle to
operating position.
1. Raise handles until lower handle section locks into
place in operating position.
2. Slide the lower knobs up towards the handle until
they stop and a click is heard.
3. Tighten the knobs to secure the handle.
4. Fold up the upper part of the handle and tighten the
knobs on both sides.
To set the cutting height
Note: Do not set the cutting height too low as there is a
risk that the blade might hit ground with unevenness.
The cutting height can be adjusted in 10 different steps.
Move the lever to the back for higher cutting height and
to the front for lower cutting height.
3
4
5
6
7
8
9
To handle the battery
WARNING! Before handling the battery,
safety on page 109 in this manual. You
should also read and understand the manual
that accompanies the battery and the battery
charger.
Battery status
The display shows the remaining battery capacity and if
there are any problems with the battery. The battery
capacity is displayed for 5 seconds after the product is
switched off or the battery indicator button is pressed.
The warning symbol on the battery is lit when an error
has occurred. See
Battery on page 118.
112
71 - 001 - 03.11.2016
