Husqvarna LC140 9676367-01 - Инструкция по эксплуатации - Страница 11

Maintenance

Introduction

WARNING: 

Before you do maintenance,

you must read and understand the safety

chapter.

For all servicing and repair work on the product, special

training is necessary. We guarantee the availability of

professional repairs and servicing. If your dealer is not a

service agent, speak to them for information about the

nearest service agent.

Maintenance schedule

The maintenance intervals are calculated from daily use

of the product. The intervals change if the product is not

used daily.
For maintenance identified with * see instructions in 

Safety devices on the product on page 8.

Maintenance

Daily

Weekly

Monthly

Do a general inspection

X

Examine the oil level

X

Clean the product

X

Examine the cutting equipment

X

Examine the cutting cover*

X

Examine the engine brake handle*

X

Examine and adjust the drive (clutch wire)

X

Examine the muffler*

X

Examine the spark plug

X

Change the oil (the first time after 5 h use, then after each 50 h use)

X

Change the air filter

X

Examine the fuel system

X

To do a general inspection

• Make sure that the nuts and screws on the product

are tightened.

To clean the product externally

• Use a brush to remove leaves, grass and dirt.
• Make sure that the air intake on the top of the engine

is not blocked.

• Do not use a high pressure washer to clean the

product.

• If you use water to clean the product, do not flush

water directly on the engine.

To clean the inner surface of the

cutting cover

1. Empty the fuel tank.
2. Put the product on its side with the muffler down.

CAUTION: 

If the product is put with the

air filter down, the engine can become

damaged.

3. Hose down the inner surface of the cutting cover

with water.

To examine the cutting equipment

WARNING: 

To prevent accidental start

remove the ignition cable from the spark

plug.

WARNING: 

Use protective gloves when you

do maintenance on the cutting equipment.

The blade is very sharp and cuts can easily

occur.

1. Examine the cutting equipment for damage or

cracks. Always replace a damaged cutting

equipment.

801 - 003 - 04.10.2018

11