Bosch ROTAK 32 LI 0600885D06 - Инструкция по эксплуатации - Страница 19

 English | 

19

Bosch Power Tools

F 016 L81 598 | (8.9.16)

Troubleshooting

STOP

Problem

Possible Cause

Corrective Action

Machine fails to oper-
ate

Possible clogging

Remove the isolator key:
Check underneath the garden product and clear 
out as necessary (always wear protective gloves)

Battery not fully charged

Battery Charging

Battery not inserted (properly) 

Inserting the battery

Grass too long

Increase height of cut and tilt garden product to re-
duce starting load

Motor protector has activated

Allow motor to cool and increase height of cut

Battery too hot/cold

Allow to cool/warm

Isolator key not inserted correctly/fully

Fit correctly

There is a short delay in the motor starting after 
engaging the On/Off switch

Hold On/Off switch for 1 – 3 s to start motor

Motor starts and stops 
immediately

Battery not fully charged

Battery Charging

Isolator key not inserted correctly/fully

Fit correctly

Battery not inserted (properly) 

Inserting the battery

Battery too hot/cold

Allow to cool/warm

Increase height of cut

Machine functions 
intermittently

Internal wiring of machine damaged

Contact Service Agent

Motor protector has activated

Allow motor to cool and increase height of cut

Machine leaves ragged 
finish

and/or

Motor labours

Height of cut too low

Increase height of cut

Cutting blade blunt

Replace the blade

Possible clogging

Check underneath the garden product and clear 
out as necessary (always wear protective gloves)

Blade fitted upside down

Refit blade correctly

Area of cut (battery 
duration) not large 
enough

Height of cut too low

Increase height of cut and walk slower

Grass too high

Increase height of cut and walk slower

Grass wet or damp

Wait until grass is dry and walk slower

Grass is dense

Increase height of cut, walk slower and cut more 
frequently

An additional battery can be purchased from an au-
thorised customer service agent for Bosch garden 
products

Contact Service Agent

Cutting blade not ro-
tating while garden 
product switched on

Cutting blade obstructed

Switch off garden product

Clear obstruction (always wear protective gloves)

Blade nut/bolt loose

Tighten blade nut/bolt (17 Nm)

Excessive vibrations/ 
noise

Blade nut/bolt loose

Tighten blade nut/bolt (17 Nm)

Cutting blade damaged

Replace the blade

No charging procedure 
possible

Battery contacts contaminated

Clean the battery contacts (e. g. by inserting and 
removing the battery several times) or replace the 
battery

The battery is defective, due to a disconnection in 
the battery (individual cells)

Replace the battery

OBJ_BUCH-1584-008.book  Page 19  Thursday, September 8, 2016  8:02 AM