AL-KO GTLI 18V COMFORT - Инструкция по эксплуатации - Страница 17

Assembly

440084_a

17

Incorrect  use  can  result  in  fluid  leaking  out

of the battery. Avoid contact with the fluid. In

case of inadvertent contact, rinse off with wa-

ter. If the fluid gets into your eye, seek additio-

nal medical assistance. 

Leaking battery fluid

can lead to skin irritations or burns.

Each  time  before  using  the  charger,  check

the housing, plug and cable for damage.
Do not use the charger if it is damaged.
Do not open the charger! Renew the charger

if it is defective.
Protect  the  appliance,  battery  and  charger

against moisture. Only charge indoors.
Only  have  electrical  appliances  repaired  by

qualified electricians, and only using genuine

spare parts. 

This ensures that the appliance

remains safe.

ASSEMBLY

CAUTION!

The  machine  must  not  be  put  in  opera-

tion before it has been assembled com-

pletely.

CAUTION!

Do  not  insert  the  battery  until  the  appli-

ance has been completely assembled.

Install the guard plate

ADVICE

The  knife  integrated  in  the  guard  plate

automatically  cuts  the  line  to  the  opti-

mum length.

1. Set  the  guard  plate  in  relation  to  the  cutter

head (2-1).

2. Make sure that the line is exposed.
3. Screw the guard plate on at the rear with the

supplied screws (2-1).

4. Place the guide wheel on the guard hood and

tighten the screws (2.2).

Installation of auxiliary handle

The holder of the auxiliary handle is mounted on

the telescopic handle. The supplied replacement

spool is integrated in the holder.

Installation of auxiliary handle

The angle of the handle can be individually adjus-

ted using the tip lever.
1. Push the holder onto the shaft.
2. Pull the grip bar of the auxiliary handle slightly

apart (3-1).

3. Push  the  auxiliary  handle  onto  the  holder

(3-2).

4. Engage the auxiliary handle in the splines.
5. Place  the  tip  lever  with  pin  holder  onto  the

clamping pin.

6. Screw  the  clamping  pin  tight  so  that  the  tip

lever can be operated with little force (3-3).

STARTUP

CAUTION!

Always  perform  a  visual  check  prior  to

start-up.

CAUTION!

Do  not  use  damaged  batteries.  Danger

of fire!

CAUTION!
Danger of explosion and fire!

The  charger  heats  up  during  charging.

Do not place it on a flammable surface or

in a flammable environment.

Charging the battery

ADVICE

The battery is supplied partially charged!

Fully  charge  the  battery  before  the  first

use.
The  battery  can  be  charged  in  any

charge level. Interrupting charging does

not damage the battery.

ADVICE

The  battery  is  protected  against  exces-

sive charging by a supply voltage control

function, which means it can be left con-

nected to the mains for some time.

1. Connect  the  charger  (1-5)  to  the  mains  wi-

thout the battery (1-4). The LED on the mains

adapter lights up green.

2. Connect the battery to the charger. The LED

on the mains adapter lights up red. Charging

starts.

ADVICE

The  temperature  range  for  charging

should be between 5 and +45 °C.
The  charging  time  for  a  full  charge  is

max.  200  minutes.  If  the  operating  time

of  the  battery  is  significantly  shorter  in

spite  of  full  charging,  this  indicates  the

battery  service  life  has  expired  and  it

must be replaced by a new, genuine bat-

tery.