Makita TW007GD201 - Инструкция по эксплуатации - Страница 8

8 ENGLISH

Indicating the remaining battery 

capacity

Press the check button on the battery cartridge to indi-

cate the remaining battery capacity. The indicator lamps 

light up for a few seconds.

► 

Fig.2:

1.

 Indicator lamps 

2.

 Check button

Indicator lamps

Remaining 

capacity

Lighted

Off

Blinking

75% to 100%

50% to 75%

25% to 50%

0% to 25%

Charge the 

battery.

The battery 

may have

malfunctioned.

NOTE:

 Depending on the conditions of use and the 

ambient temperature, the indication may differ slightly 

from the actual capacity.

NOTE:

 The first (far left) indicator lamp will blink when 

the battery protection system works.

Switch action

► 

Fig.3:

1.

 Switch trigger

CAUTION:

Before installing the battery car-

tridge into the tool, always check to see that the 

switch trigger actuates properly and returns to 

the "OFF" position when released.

To start the tool, simply pull the switch trigger. Tool 

speed is increased by increasing pressure on the switch 

trigger. Release the switch trigger to stop.

NOTE:

 The tool automatically stops when you keep 

pulling the switch trigger for 6 minutes.

NOTE:

 When full speed mode is turned on, the rota-

tion speed becomes fastest even if you do not pull the 

switch trigger fully.
For detail information, refer to the section of full speed 

mode.

Lighting up the front lamp

CAUTION:

Do not look in the light or see the 

source of light directly.

► 

Fig.4:

1.

 Lamp

► 

Fig.5:

1.

 Button 

To turn on the lamp status, press the button   for 

one second. To turn off the lamp status, press the but

-

ton   for one second again.

With the lamp status ON, pull the switch trigger to turn 

on the lamp. To turn off, release it. The lamp goes out 

approximately 10 seconds after releasing the switch 

trigger.

With the lamp status OFF, the lamp does not turn on 

even if pulling the trigger.

NOTE:

 To confirm the lamp status, pull the trigger. 

When the lamp lights up by pulling the switch trigger, 

the lamp status is ON. When the lamp does not come 

on, the lamp status is OFF.

NOTE:

 When the tool is overheated, the light flashes 

for one minute, and then the LED display goes off. In 

this case, cool down the tool before operating again.

NOTE:

 Use a dry cloth to wipe the dirt off the lens of 

the lamp. Be careful not to scratch the lens of lamp, or 

it may lower the illumination.

NOTE:

 While pulling the switch trigger, the lamp 

status cannot be changed.

NOTE:

 For approximately 10 seconds after releasing 

the switch trigger, the lamp status can be changed.

Reversing switch action

► 

Fig.6:

1.

 Reversing switch lever

CAUTION:

Always check the direction of 

rotation before operation.

CAUTION:

Use the reversing switch only after 

the tool comes to a complete stop.

 Changing the 

direction of rotation before the tool stops may dam-

age the tool.

CAUTION:

When not operating the tool, 

always set the reversing switch lever to the neu-

tral position.

This tool has a reversing switch to change the direction 

of rotation. Depress the reversing switch lever from the 

A side for clockwise rotation or from the B side for coun-

terclockwise rotation.

When the reversing switch lever is in the neutral posi-

tion, the switch trigger cannot be pulled.