Makita DTD155RME - Инструкция по эксплуатации - Страница 7

7 ENGLISH

NOTE:

 To confirm the lamp status, pull the trigger. 

When the lamp lights up by pulling the switch trigger, 

the lamp status is ON. When the lamp does not come 

on, the lamp status is OFF.

NOTE:

 When the tool is overheated, the light flashes 

for one minute, and then the LED display goes off. In 

this case, cool down the tool before operating again.

NOTE:

 Use a dry cloth to wipe the dirt off the lens of 

the lamp. Be careful not to scratch the lens of lamp, or 

it may lower the illumination.

Reversing switch action

► 

Fig.7:

1.

 Reversing switch lever

CAUTION:

Always check the direction of 

rotation before operation.

CAUTION:

Use the reversing switch only after 

the tool comes to a complete stop.

 Changing the 

direction of rotation before the tool stops may dam-

age the tool.

CAUTION:

When not operating the tool, 

always set the reversing switch lever to the neu-

tral position.

This tool has a reversing switch to change the direction 

of rotation. Depress the reversing switch lever from the 

A side for clockwise rotation or from the B side for coun

-

terclockwise rotation.

When the reversing switch lever is in the neutral posi-

tion, the switch trigger cannot be pulled.

Changing the impact force

► 

Fig.8:

1.

 Hard 

2.

 Soft 

3.

 A mode 

4.

 Changed in three 

steps 

5.

 Button

You can change the impact force in three steps: hard, 

soft, and A mode.

This allows a tightening suitable to the work.

Every time the button is pressed, the number of blows 

changes in three steps.

“A mode (assist mode)” is an easy-to-use mode for 

driving screws with good control. 

In this mode, the tool drives a screw with low-speed 

rotation at first. After the tool starts to impact, the rota

-

tion speed increases and reaches the maximum speed.
For approximately one minute after releasing the switch 

trigger, the impact force can be changed.

Impact force grade displayed 

on panel

Maximum blows

Purpose

Example of application

Hard

3,900 min

-1

 (/min)

Tightening when force and 

speed are desired.

Tightening wood screws, 

tightening bolts.

Soft

1,600 min

-1

 (/min)

Tightening with less force to 

avoid screw thread breakage.

Tightening sash screws, tight

-

ening small screws such as M6.

A mode

3,900 min

-1

 (/min)

Tightening screws with better 

control.

Tightening long screws.

NOTE:

 A mode is available only when the tool rotates clockwise. When rotating counterclockwise in A mode, the 

impact force and speed are the same as hard mode.

NOTE:

 When all lamps on the switch panel go out, the tool is turned off to save the battery power. The impact force 

grade can be checked by pulling the switch trigger to the extent that the tool does not operate.

NOTE:

 While pulling the switch trigger, the impact force grade cannot be changed.