Einhell CC-IW 450 (2048304) - Инструкция по эксплуатации - Страница 17

GB

- 17 -

sening screws/nuts. If you wish to use the 

impact driver to tighten screws and nuts, 

you must also use a torque limiter which is 

designed for this purpose. If not, the screw 

connection may be damaged. A torque limiter 

is available from your dealer. It is not supplied 

with this tool.

• 

Prior to tightening, carefully insert the screw/

nut into the threads.

• 

It is important that screws/nuts with special 

torque specifications (for example provided 

by the vehicle manufacturer in the automoti-

ve sector) are tightened only with a suitable 

torque limiter.

Hazard!

Always tighten and check screws/nuts with a 

torque wrench set to the torque speci

fi

 ed by the 

manufacturer.

7.  Replacing the power cable

Danger!

If the power cable for this equipment is damaged, 

it must be replaced by the manufacturer or its 

after-sales service or similarly trained personnel 

to avoid danger.

8.  Cleaning, maintenance and 

ordering of spare parts

Danger!

Always pull out the mains power plug before star-

ting any cleaning work.

8.1 Cleaning

• 

 Keep all safety devices, air vents and the 

motor housing free of dirt and dust as far as 

possible. Wipe the equipment with a clean 

cloth or blow it with compressed air at low 

pressure.

• 

 We recommend that you clean the device  

immediately each time you have finished 

using it.

• 

 Clean the equipment regularly with a moist 

cloth and some soft soap. Do not use 

cleaning agents  or solvents; these could at-

tack the plastic parts of the equipment. Ensu-

re that no water can seep into the device. The 

ingress of water into an electric tool increases 

the risk of an electric shock.

8.2 Carbon brushes

In case of excessive sparking, have the carbon  

brushes checked only by a quali

fi

 ed electrician.

Danger!

 The carbon brushes should not be rep 

laced by anyone but a quali

fi

 ed electrician.

8.3 Maintenance

There are no parts inside the equipment which  

require additional maintenance.

8.4 Ordering spare parts and accessories

Please provide the following information when 

ordering spare parts:

• 

Type of unit

• 

Article number of the unit

• 

ID number of the unit

• 

Spare part number of the required spare part

For our latest prices and information please go to 

www.isc-gmbh.info

Tip! For good results we 

recommend high-quality ac-

cessories from 

! 

www.kwb.eu 

welcome@kwb.eu

9.  Disposal and recycling

The equipment is supplied in packaging to pre-

vent it from being damaged in transit. The raw 

materials in this packaging can be reused or 

recycled. The equipment and its accessories are 

made of various types of material, such as metal 

and plastic. Never place defective equipment in 

your household refuse. The equipment should 

be taken to a suitable collection center for proper 

disposal. If you do not know the whereabouts of 

such a collection point, you should ask in your 

local council o

ffi

  ces. 

10. Storage

Store the equipment and accessories in a dark 

and dry place at above freezing temperature. The 

ideal storage temperature is between 5 and 30 

°C. Store the electric tool in its original packaging.

Anl_CC_IW_450_SPK9.indb   17

Anl_CC_IW_450_SPK9.indb   17

22.03.2018   13:28:09

22.03.2018   13:28:09