STATUS RH-1800 - Инструкция по эксплуатации - Страница 10

10

EN

• 

After working with low rotation speed for a long time, allow the machine to cool down 

for about 2 minutes with it running idle at maximum rotation speed. 

Adjustment with an arbitrary object

You can simply cut as deep as the height of any chosen object.

• 

Set the adjustable depth stopper (7) so that the height measuring stick is brought 

down to the lowest level.

• 

Loosen the set screw (8) of the depth measuring stick.

• 

Loosen the height adjuster (12) and press the mould cutting tool with the handle far 

under, so that it touches the work piece.

• 

Secure this adjustment by tightening the height adjuster.

• 

Lift the depth measuring stick (9) up.

• 

Lay your selected object between the lowest level of the depth stopper (7) and the 

depth measuring stick (9). The metal point (b1) of the depth measuring stick (9) must 

touch the selected object.

• 

Secure this adjustment by tightening the set screw (8) of the depth measuring stick.

• 

The mould cutter depth is now set.

• 

Now loosen the height adjuster to get the mould cutter ready for operation.

Calibration in 3 mm intervals

The adjustable depth stopper (7) allows a quick approximate adjustment in 3 mm intervals.

• 

Insert the appropriate mould cutter.

• 

Set the adjustable depth stopper (7), so that the height measuring stick shows the 

lowest level when brought down.

• 

Loosen the set screw (7) of the depth measuring stick.

• 

Loosen the height adjuster (12) and press the mould cutting tool with the handle far 

under, so that it touches the work piece.

• 

Secure this adjustment by tightening the height adjuster.

• 

Lift up the depth measuring stick (9) a little.

• 

Now adjust the depth stopper by turning it.

• 

For every step that it climbs, an additional 3 mm is added to the mould cutter depth. 

So when it is at position 3, the mould cutter depth is 9 mm.

• 

Adjust the depth measuring stick with the metal point (b1) so that it is on the desired 

step, while you tighten the set screw (8) of the depth measuring stick.

Calibration calculation

You know the exact cutting depth in centimeters and would like to change it. You would 

like to drill exactly a 2 mm deep screw into a wooden board, for example.

• 

Insert the appropriate mould cutter.

• 

Adjust the depth stopper (7), so that the height measuring stick shows the lowest level 

when brought down.

OPERATION