STATUS CP 115 07410601 - Инструкция по эксплуатации - Страница 7

7

Chain saw safety warnings

EN

• 

When an extension cable is required, you must en ure that it has the right ampere 

rating for your power tool and it is in safe electrical condition.

• 

WARNING: Always switch off and unplug the power tool prior to any adjustment, 

servicing or maintenance.

• 

While operating the machine, always hold it firmly with both hands and provide for a 

secure stance. The power tool is guided more securely with both hands.

• 

Always keep the cable away from the working area of the power tool. Keep cable or 

extension cable away from oil, sharp edges or heat sources.

• 

Never use the machine with a damaged cable. Do not touch the damaged cable and 

pull the mains plug when the cable is damaged while operating. Damaged cables 

increase the risk of electric shock.

• 

Check regularly the cable and the extension cable. In case of damage disconnect 

immediately the cable from the mains. If the replacement of the cable is necessary, this 

has to be done by the manufacturer or his agent in order to avoid a safety hazard.

• 

Always be sure you have a firm footing. Be sure no one is below when using the tool in 

high locations.

• 

Keep work area clean.

• 

 he tool must be used only for its prescribed purpose. Any use other than those 

mentioned in this manual will be considered a case of misuse. The user and not the 

manufacturer shall be liable for any damage or injury resulting from such cases of 

misuse.

• 

To use this tool properly, you must observe the safety regulations, the assembly 

instructions and the operating instructions found in this manual. All persons who 

use and service the machine have to be acquainted with this manual and must be 

informed about its potential hazards.

• 

Children and frail people must not use this power tool. Children should be supervised 

at all times if they are in the area in which the tool is being used. It is also imperative 

that you observe the accident prevention regulations in force in your area. The same 

applies for general rules of occupational health and safety.

• 

The manufacturer shall not be liable for any changes made to the tool nor for any 

damage resulting from such changes.

• 

Do not operate the machine if the chain is damaged or heavily worn out.

• 

Switch off and unplug the machine and prior to: transportation, conservation, 

inspection or maintenance. Place the sheath on the guide bar when transporting the 

chain saw or during storage.

• 

Do not operate the machine in the presence of flammable gases or liquids.

• 

Carry the chain saw by the front handle with the guide bar pointing forward.

• 

Never carry the chain saw by the cable.

• 

Familiarize with the chain saw capabilities and do not attempt operations which might 

overload it.