STATUS CP 115 07410601 - Инструкция по эксплуатации - Страница 6

6

• 

Carry the chain saw by the front handle with the saw chain stopped and the guide bar 

pointing to the rear. When transporting or storing the chain saw always fit the guide 

bar cover. Proper handling of the chain saw will reduce the likelihood of accidental 

contact with the moving saw chain.

• 

Follow instructions for lubricating, chain tensioning and changing accessories. 

Improperly tensioned or lubricated chain may either break or increase the chance for 

kickback.

• 

Keep handles dry, clean, and free from oil and grease. Greasy, oily handles are slippery 

causing loss of control.

• 

Cut wood only. Don’t use chain saw for purposes not intended – for example – Don’t 

use chain saw for cutting plastic, masonry or non-wood building materials. Use of the 

chain saw for operations different then intended could result in a hazardous situation.

Causes and operator prevention of kickback:

• 

Kickback may occur when the nose or tip of the guide bar touches an object, or when 

the wood closes in and pinches the saw chain in the cut. Tip contact in some cases 

may cause a sudden reverse reaction, kicking the guide bar up and back towards the 

operator. Pinching the saw chain along the top of the guide bar may push the guide 

bar rapidly back towards the operator. Either of these reactions may cause you to lose 

control of the saw which could result in serious personal injury. Do not rely exclusively 

upon the safety devices built into your saw. As a chain saw user, you should take 

several steps to keep your cutting jobs free from accident or injury. Kickback is the 

result of tool misuse and/or incorrect operating procedures or conditions and can be 

avoided by taking proper precautions as given below:

• 

Maintain a firm grip, with thumbs and fingers encircling the chain saw handles, with 

both hands on the saw and position your body and arm to allow you to resist kickback 

forces. Kickback forces can be controlled by the operator, if proper precautions are 

taken. Do not let go of the chain saw.

• 

Do not over reach and do not cut above shoulder height. This helps prevent 

unintended tip contact and enables better control of the chain saw in unexpected 

situations.

• 

Only use replacement bars and chains specified by the manufacturer. Incorrect 

replacement bars and chains may cause chain breakage and/ or kickback.

• 

Follow the manufacturer’s sharpening and maintenance instructions for the saw chain. 

Decreasing the depth gauge height can lead to increased kickback.

• 

A power source with a voltage greater than that specified for the tool can result in 

serious injury to the user, as well as damage to the tool.

• 

If in doubt, do not plug in the tool.

• 

Using a power source with a voltage less than the nameplate rating is harmful to the 

motor.

• 

Fully unwind cable drum extensions to avoid potential overheating.

EN

Chain saw safety warnings