Электропилы AL-KO HT 600 FLEXIBLE CUT - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
17
470519_b
HT 600, HT 700
GB
Operation
Danger – risk of injury!
The machine must not be operated before as-
sembly work has been completed!
Observe the safety instructions for operation!
Adjust the front hand grip.
1.
Pull out the quick-release lever
a.
Move the hand grip to the desired position
b.
Push the quick-release lever back in
c.
2. Plug the power cable into the mains power
supply.
3. Grip the front hand grip with one hand, then grip
the rear hand grip with the other hand.
4. Press the switches on both hand grips ( 4) –
the machine will start.
5. Keep both switches pressed while working.
6. The hedge trimmer will stop immediately if one
of the switches is released.
Work instructions
Always cut both sides of the hedge
fi
rst, before
cutting the top.
This will prevent cut material from falling into
areas that have not yet been cut.
The built-in spirit level facilitates cutting along
a straight line ( 5).
Hedges should always be cut in a trapezoid
shape. This prevents the lower branches from
becoming bare ( 8).
Repairs
Repair work may only be carried out by compe-
tent specialist workshops or our AL-KO Service
Centres.
Safety instructions for operation
Always operate the machine with both
hands.
Keep body and clothing away from cutting
parts.
Do not remove cut material while the mo-
tor is running.
When leaving unattended / transporting
the machine:
Switch the machine off.
Pull out the mains plug.
Push on the safety cover.
Never hold the machine by the blade.
Only carry the machine by the hand grip.
The domestic mains voltage must match
the mains voltage specifi cations in the
technical data.
Always use the special cable strain relief
for the extension lead.
Always keep the cable out of the cutting
area and routed away from the machine.
Assembly
The camera symbol refers to illustrations on
page 3.
Fasten the handguard to the housing using the
1.
screws provided ( 1).
Pull the hand grip apart slightly and push it onto
2.
the housing ( 2a). The toothing must click
into place.
Pull out the quick-release lever on the hand grip
3.
and hold it in place.( 2b)
Push the clamping bolt through the hand grip
4.
and housing and screw it into the quick-release
lever by hand. ( 2c)
Screw the clamping bolt in so far that the quick-
5.
release lever can be pushed against the hand
grip with little force.
Route the extension lead through the strain
6.
relief ( 3).
