Philips RQ1087 - Инструкция по эксплуатации - Страница 17

  1 

 Remove the shaver from the Power Pod or the Jet Clean System.

  2 

 Let the shaver run until it stops.

 Pull the shaving unit off the shaver.

 Undo the 2 screws on the back of the shaver.  (Fig. 6)

  5 

 Insert a screwdriver between the front and back panel to open 

the shaver.  (Fig. 7)

  6 

 Remove the side panels (Fig. 8).

  7 

 Unscrew the  screws on the inside of the shaver and remove the 

back cover (Fig. 9).

  8 

 Pull the wires out of the motor unit and remove the 

battery (Fig. 50).

Be careful, the battery strips are sharp.
Do not put the shaver back into the plugged-in Power Pod or Jet Clean 

System after you have removed the battery.

guarantee & service

If you need ser vice or information or if you have a problem, please visit 

the Philips website at 

www.philips.com

 or contact the Philips Consumer 

Care Centre in your countr y (you find its phone number in the 

worldwide guarantee leaflet). If there is no Consumer Care Centre in 

your countr y, go to your local Philips dealer.

guarantee restrictions

The shaving heads (cutters and guards) are not covered by the terms of 

the international guarantee because they are subject to wear.

Frequently asked questions

  1 

 Why doesn’t the shaver shave as well as it used to?

The Jet Clean System may not have cleaned the shaver properly, 

because the cleaning fluid in the cleaning chamber is soiled or the 

-

English

19