Braun 7680 - Инструкция по эксплуатации - Страница 7

7

Display

The pilot light shows that the shaver is connected to the 
mains.
The display shows the operation mode and charging 
status of the shaver: During charging, the display shows 
the battery capacity symbol increasing by 20% 
segments and the charging time remaining (flashing):

First charging (4 h):

The display counts down in 20 min. steps.

Subsequent chargings (1 h):

The display counts down in 5 min. steps.

The batteries are fully charged. SmartLogic inside 
monitors  the batteries and communicates «Test...ok» 
when it is still well charged. Below 10 minutes remaining 
shaving time, the display shows the minutes left. 
The «moving» plug symbol indicates that you should 
charge your shaver. If there is insufficient battery 
charge for a cordless shave, either recharge the shaver 
or shave via the power supply cord connected to the 
mains.

*

The display changes to this format when the shaver is in 
the Clean&Charge.

The SmartLogic inside your shaver automatically 
monitors  the condition of the batteries as well as the 
charging/discharging processes and adapts them to 
your personal shaving patterns. For instance, if it is your 
routine to never let the batteries run low, the SmartLogic 
will recognize this, look for a pause when you are likely 
to not use the shaver, completely discharge and then 
recharge your shaver to recondition the batteries (every 
six months at the most, and only when necessary).

For additional information, press the info key:

press once: 
– to display the duration of the last shave

press again:
– to display the key part number for shaver foil and 

cutter block

hold for 3 secs:
– to run a display demo

*

*