Braun 7680 - Инструкция по эксплуатации - Страница 12

12

Before using Clean&Charge

For the first charge of the shaver, connect the power 
supply cord set directly to the shaver, charge it for 
4 hours and shave at least once. 
Only then can the shaver be cleaned or recharged in the 
Clean&Charge.

If the rechargeable batteries are discharged, select the 
combined «clean + charge» program rather than the 
«clean» program alone. 

Installing the cartridge

• Press the lift button (12) to open the housing.

• Hold the cartridge down on a flat, stable surface 

(e.g. table). Carefully remove the lid from the cartridge. 
Slide the cartridge into the base as far as it will go.

• Slowly close the housing by pushing it down until it 

locks.

Replacing the cartridge

After having pressed the lift button to open the housing, 
wait for a few seconds before removing the used 
cartridge. 

Before discarding the used cartridge, make sure to close 
the openings using the lid of the new cartridge, since the 
used cartridge will contain contaminated cleaning 
solution.

Operating your Clean&Charge

Use the power supply cord set from your shaver and 
plug it into the Clean&Charge and then into a main outlet. 
Open the contact bow (13) by pressing the release 
button (14). After shaving, switch the shaver off and 
place it upside down into the Clean&Charge (without 
having released the shaver foil).

• Select the operation mode by toggling with the mode 

selector (15):
clean

(about 15 min)

clean + charge (about 75 min)
charge

(about 60 min)

The corresponding lights will come on.
(With cord shavers, only the «clean» function can be 
selected.)

2

1

old

new

new

7680

a

u

to

m

a

tic

lo

c

k

3

2

1

0

a

u

to

m
a

tic

lo

c

k

3

2

1

0

on/o

ff

clean

ch

arg

e

cart

ridg

e

7680

7680