Braun 5612 - Инструкция по эксплуатации - Страница 5

5

Dry cleaning

Instead of cleaning under running water, you 
may dry clean your shaver: turn the shaver off, 
remove the shaver foil (shaver head must be in 
central position) and, using the brush, clean 
the cutter block and the inner area of the 
shaver head. 
Do not clean the shaver foil with the brush. 

General cleaning

About every four weeks, clean the cutter block 
with Braun cleaning agents. 
Put a drop of light machine oil onto the long 
hair trimmer and shaver foil.

Replacing the shaving parts 

The shaver foil and cutter block are precision 
parts that, in time, are subject to wear. 
Replace your foil frame and cutter block every 
18 months and get a 25% better shave.*
(Shaver foil and cutter block: part no. F/C505, 
available at your dealer or Braun Service 
Centres)

* (Overall evaluation from Braun users 

comparing their shave with new parts and 
those used for 18 months.)

Preserving the batteries 

In order to maintain the optimum capacity 
of the rechargeable batteries, the shaver has 
to be fully discharged (by shaving) every 
6 months approximately. Then recharge the 
shaver to full capacity again. 
Do not expose the shaver to temperatures of 
more than 50 °C for longer periods of time. 

Environmental notice

This appliance is provided with nickel-
cadmium batteries. To protect the environ-
ment, do not dispose of this appliance in the 
household waste at the end of its useful life. 
Disposal can take place at a Braun Service 
Centre or appropriate collection sites. 
However, if you prefer to dispose of the 
product yourself, remove the batteries as 
shown on page 29.

Subject to change without notice.

This product conforms to the EMC-
Requirements as laid down by the 
Council Directive 89/336/EEC and to the 
Low Voltage Regulation (73/23 EEC).

5720453_5612/10_AMEE  Seite 5  Dienstag, 28. Mai 2002  1:37 13