Franke FSL 86 H WH - Инструкция по эксплуатации - Страница 10

10

CLEANING AND MAINTENANCE

EXTERIOR SURFACES

• Clean the surfaces with a damp microfibre cloth� 

If they are very dirty, add a few drops of pH-neutral 

detergent� Finish off with a dry cloth� 

• Do not use corrosive or abrasive detergents� If any of 

these products inadvertently comes into contact with 

the surfaces of the appliance, clean immediately with 

a damp microfibre cloth�

INTERIOR SURFACES

• After every use, leave the oven to cool and then 

clean it, preferably while it is still warm, to remove 

any deposits or stains caused by food residues� To 

dry any condensation that has formed as a result of 

cooking foods with a high water content, allow the 

oven to cool completely and then wipe it with a cloth 

or sponge�

• 

Activate the “Steam Cleaning” function for optimum 

cleaning of the internal surfaces�

• The door can be easily removed and refitted to 

facilitate cleaning of the glass�

• Clean the glass in the door with a suitable liquid 

detergent� 

• The top heating element of the grill can be lowered 

to clean the upper panel of the oven �

ACCESSORIES

Soak the accessories in a washing-up liquid solution 

after use, handling them with oven gloves if they 

are still hot� Food residues can be removed using a 

washing-up brush or a sponge�

Do not use steam cleaning 

equipment.
Use protective gloves during all 

operations.

Carry out the required 

operations with the oven cold.
Disconnect the appliance from 

the power supply.

Do not use wire wool, abrasive 

scourers or abrasive/corrosive 

cleaning agents, as these could 

damage the surfaces of the 

appliance.

REMOVING AND REFITTING THE DOOR

1. 

To remove the door

, open it fully and lower the 

catches until they are in the unlock position�

2. 

Close the door as much as you can� 

Take a firm hold of the door with both hands – do not 

hold it by the handle�

Simply remove the door by continuing to close it 

while pulling it upwards (a) at the same time until it is 

released from its seating (b)�

~60°

a

b

~15°

Put the door to one side, resting it on a soft surface�

3. 

Refit the door

 by moving it towards the oven, 

aligning the hooks of the hinges with their 

seating and securing the upper part onto its 

seating�

4. 

Lower the door and then open it fully�  

Lower the catches into their original position: 

Make sure that you lower them down completely� 

5. 

Try closing the door and check to make sure that 

it lines up with the control panel� If it does not, 

repeat the steps above�

PRESS TO CLEAN

 - CLEANING THE GLASS

1. 

After removing the door and resting it on 

a soft surface with the handle downwards, 

simultaneously press the two retaining clips and 

remove the upper edge of the door by pulling it 

towards you� 

2. 

Lift and firmly hold the inner glass with both 

hands, remove it and place it on a soft surface 

before cleaning it�

3. 

To correctly reposition the inner glass, make sure 

that the “R” is visible in the left-hand corner� First 

insert the long side of the glass indicated by “R” 

into the support seats, then lower it into position�

4. 

Refit the upper edge: a click will indicate correct 

positioning� Make sure the seal is secure before 

refitting the door�