VITEK VT-1476 CM/GR - Инструкция по эксплуатации - Страница 5

5

              ENGLISH         

•  In order not to damage the blades, do not 

process very hard products, such as ice, 
frozen products, grits, rice, seasonings 
and coffee.

Using the whisk attachment

Use the whisk attachment only for making 
cream, biscuit dough or mixing ready des-
serts.
NOTE: Before assembling, make sure that 
the power plug is not inserted into the 
socket.
• Insert the whisks (7) into the gear head 

(6).

• Insert the gear head (6) into the motor 

unit (1) and turn it clockwise until clamp-
ing.

•  Insert the plug into the socket.
• Put the whisk attachment into the bowl 

with products or use the bowl for mixing 
products (8), use the control (4) to set 
the required speed 1-7, press and hold 
the (2) button during the operation. When 
Turbo (3) button is pressed, the whisks 
will rotate at maximal speed. 

USING THE BLADES

The blade is used to chop meat, cheese, 
onion, aromatic herbs, garlic, carrot, wal-
nuts, almond, and fruits.

Attention! Do not chop very hard prod-
ucts, such as nutmegs, coffee beans 
and cereals.
Before you start to chop:

• Cut meat, cheese, onion, garlic, carrots 

into (approximately equal) slices.

• Remove stems from herbs, peel the 

nuts.

• Remove bones, tendons and cartilage 

from meat.

• Remove the “protecting housing” fr

om 

the blades (18).

Chopping

NOTE: Do not overfill the processor bowl.

Be careful: The blades are very sharp!
Always hold the blade by the plastic tip.
1.  Put the drive shaft (17) on the proces-

sor bowl axis (16).

2.  Put the blade (18) on the splines of the 

drive shaft (17).

3.  Put the products into the processor 

bowl (16).

4.  Put the lid (13) on the bowl (16).
5.  Put the gear lid (9) and lock it on the 

bowl (16).

6.  Put the motor unit (1) on the gear lid (9) 

and turn it clockwise until clamping.

7.  Use the control (4) to set the required 

speed 1-7. To switch on the unit, press 
and hold the (2) button. When pressing 
Turbo (3) button, the blade will rotate at 
maximal speed. During operation hold 
the motor unit (1) with one hand, and 
the bowl (16) with the other hand.

8.  After usage of the unit, take the plug 

out of the socket, press the (10) button 
and, holding it, disconnect the motor 
unit (1) from the lid (9), rotating it coun-
terclockwise.

9.  Then remove the gear lid (9) from the 

bowl (16), by pressing the (11) buttons.

Note: it is impossible to remove the 
lid (9) from the bowl, if the motor 
unit (1) is not disconnected.

10. Carefully remove the blade (18).
11. Remove the chopped products from 

the processor bowl (16).

12. Clean, wash and dry all the used details 

immediately after operation.

13. Put the protective housing on the blade 

(18).

Attention! Time of continuous opera-
tion should not exceed 30 sec.

Using the discs with graters/shredders

1.  Put the drive shaft (17) on the proces-

sor bowl axis (16)

1476.indd   5

1476.indd   5

25.01.2011   12:48:38

25.01.2011   12:48:38