VITEK VT-1476 CM/GR - Инструкция по эксплуатации - Страница 4

4

• Do not use the unit near hot surfaces 

(gas or electric stove, oven).

•  Check the power cord and the plug peri-

odically. Do not use the unit if the power 
plug or the cord is damaged.

•  Do not try to repair the unit by yourself. If 

there are any damages in the unit apply 
to the authorized service center.

•  Do not exceed the recommended quan-

tity of products while processing them.

• Immediately after operation, switch off 

the processor and take the plug out of 
the socket.

•  Do not pull the power cord, do not twist it 

and do not wind over the unit.

• Do not touch the power plug with wet 

hands.

• Close supervision is necessary when 

children or disabled persons are near the 
operating unit.

• This unit is not intended for usage by 

children or disabled persons unless they 
are given all the necessary instructions 
on safety measures and information 
about danger, which can be caused by 
improper usage of the unit.

•  Keep the unit out of reach of children.
• Do not allow the children to use the unit 

as a toy.

•  The unit is intended for household usage 

only.

PREPARATION FOR OPERATION

• Before using the unit, wash the attach-

ments contacting products, with warm 
water with a neutral detergent, and dry 
them thoroughly.

•  W ipe the motor unit (1) with a soft, slight-

ly dampened cloth.

• Do not immerse the motor unit (1), the 

whisk gear head (6), and the lid-gear (9), 
as well as the power cord and the power 
plug into water or other liquids.

• Do not place the attachments into the 

dishwashing machine.

USING THE BLENDER AT TACHMENT

NOTE: before assembling, make sure that 
the power plug is not inserted into the 
socket.
• Insert the attachment (5) into the motor 

unit (1) and turn it clockwise until clamp-
ing.

•  Insert the plug into the socket.
•  The unit is ready for operation.
• Put the blender attachment (5) into the 

bowl with the products, which you want 
to chop/blend or use the bowl for mixing 
products (8).

Note:
Put the products into the bowl before 
switching on the unit. Do not overfill the 
bowl for mixing products (8).
Before blending, we recommend peel-
ing the fruits, removing inedible parts, 
such as bones, cutting fruits into 2,5 
cm cubes.
Be careful! The blade of the blender at-
tachment is sharp.
Do not blend/chop products without 
water.
Time of continuous operation should 
not exceed 30 sec.

• Use the speed control (4) to set the re-

quired speed 1-7.

• Press and hold the (2) button to switch 

on the unit. Use this mode for blending 
liquid products.

•  When pressing Turbo (3) button, the unit 

will be operating at maximal speed. Use 
this mode for combined processing of 
liquid and hard products.

• After you finish operating the unit, take 

the plug out of the socket, and then re-
move the attachment (5).

• Clean and wash all the attachments, 

which were used, immediately after op-
eration.

•  Do not remove the (5) attachment during 

operation of the unit.

 ENGLISH

1476.indd   4

1476.indd   4

25.01.2011   12:48:38

25.01.2011   12:48:38