Блендеры BRAYER BR1246 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
12
EN
• When you press and hold the button (4) « » you can
control the disc (15 or 16) rotation speed by turning
the control knob (5).
• For operation at the maximal rotation speed, press
and hold down the button (3) «T».
• During the operation put the products into the pusher
opening and use the pusher (9) to feed products.
Press the pusher (9) gently while feeding products.
Never push products with your hands or other
objects, use the pusher (9) only.
•
Watch the filling of the bowl (13), as it fills, switch the
blender off and remove the food from the bowl (13).
•
Release the button (3 or 4) to switch off.
• After using the unit, wait until the chopping knife (11)
fully stops.
• Remove the power plug from the mains socket.
• Disconnect the motor unit from the lid (10) by
pressing the release buttons (2) (pic. 6).
• Remove the lid (10) from the bowl (13) by turning the
lid (10) counterclockwise.
• Remove the knife (11), take the cubic attachment
(12) out of the bowl (13).
• Take the products out of the bowl (13).
CLEANING
CUBIC ATTACHMENT
Continuous operation time while using the cubic
attachment should not exceed 3 cycles of 10
seconds each. Make at least a 3 minutes break
between the operation cycles.
• Use the cubic attachment for cutting soft fruit and
boiled vegetables into cubes.
ATTENTION!
Do not use the attachment for
processing hard or frozen products to avoid damaging
it.
• Before assembling make sure that the power plug is
not inserted into the mains socket.
•
Place the bowl (13) on a flat and steady surface.
• Install the cubic attachment (12) into the bowl (13),
the groove on the attachment (12) should match the
ledge on the bowl (13).
• Install the cubic knife (11) on the attachment (12).
• Place the lid (10) on the bowl (13) and turn it
clockwise as far as it will go.
• Press on the locks (2) and install the motor unit on
the lid (10) feeding chute, make sure that the motor
unit is fixed properly. Install the motor unit evenly in
vertical position (pic. 6).
• Insert the pusher (9) into the lid (10) opening.
• Insert the power plug into the mains socket.
• To switch the unit on, press and hold down the button
(4) « ».
ATTENTION!
The blades of the chopping knife (9)
are very sharp and may be dangerous. Handle the
chopping knife (9) very carefully!
