Акустика Sven SPS-750 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Fig. 4. Remote control
ENG
Operation Manual
19
SPS-750
Remote control
(Fig. 4)
a
: power switch button (ST-BY mode)
b
BT: Bluetooth mode selection button
c
AUX 1: AUX 1 selection button
d
AUX 2: AUX 2 selection button
e
VOL +/-: volume up/down button
f
/ : previous track/next track
(Bluetooth mode)
g
BASS : bass control knob
h
TREBLE: treble control knob
i
: Mute button
j
OPTICAL: кнопка выбора оптического входа
k
RESET: return to default settings
l
:Play / Pause (Bluetooth mode)
Notes:
• It is necessary to remove the film-gasket
protruding from the remote control battery
compartment before the starting operation.
• Use the remote control at an angle no more
than 30 degrees, no more than 7 meters away
from the IR receiver.
• Direct the RC at the IR receiver display on the
control panel.
• If the RC isn’t working, check the battery and
replace the discharged battery with a new one.
• Remove the battery from the remote control if
the device is left unused for a long period of
time (more than a week).
e
e
b
d
c
i
f
k
g
a
j
f
g
OPTICAL
h
h
l
5.
PREPARATION AND OPERATION
Speaker placement
•
Place the speakers symmetrically to the listener at least one meter away.
•
Bass reflex ports are located at the rear panels of speaker cabinets, please locate the speakers
about 20–30 cm away from the wall or any other obstacle.
MSS сonnecting and control
SPS-750 Multimedia Speaker System can be connected to virtually any audio source: DVD/CD, PC
sound card, etc. (see connection diagram in Fig. 5).
•
Before making any connections, make sure that the MSS is unplugged. Connect the active speaker
with the passive one using the audio cable (included). To do this, release connector terminals on
the passive speaker, insert the audio cable black and white wire into red jack and the black wire into
the black jack of connecting terminals (see connection diagram in Fig. 5), and then connect the
cable to the active speaker terminals in the same way.
