Акустика Sven MS-2100 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
ENG
25
Operation Manual
MS-2100
Clock Mode
•
When the MSS is in the ST-BY mode, the display
a
shows the current time. When the system is in
a di
ff
erent mode, to see the time, use the CLOCK button
j
on the remote control. The current time
will be displayed for 3-5 seconds.
•
To set the current time, go to the ST-BY mode by pressing long INPUT button
h
on the front
panel or button
q
on the remote control. To enter the time setting mode, press the SET button
l
on the remote control (the corresponding position will start blinking on the display
a
). Set the
minutes and hours directly from the RC numeric pad or using buttons
e
,
g
on the front panel or
d
,
m
on the RC. To switch between setting hours/minutes and to exit the setting mode, press the
RC SET button
l
short.
ST-BY Mode
•
To enter/exit this mode, press and hold down INPUT button
h
on the front panel or button
q
on
the remote control. When the MSS is in the ST-BY mode, the display
a
shows the current time.
MUTE Mode
•
To enter the MUTE mode, press button
o
on the remote control. To exit the MUTE mode, press
this button
o
again.
Note. Due to the constant development of the software, the actual MSS operation may differ
from that described in this Manual. The most recent version of the Manual is available at
www.sven.
fi
.
If none of the above methods can solve the problem, please seek professional advice at your
nearest service center. Never attempt to repair the product yourself.
Problem
The MSS does not
turn on.
No sound or the
sound is too quiet.
Distortion of sound.
The remote control
is not working.
Cause
The MSS isn’t connected to a mains
outlet.
The power switch is o
ff
.
Volume level is set at minimum value.
Improperly connected audio source.
Large amplitude of the input signal.
The batteries are discharged.
Solution
Check the connection.
Turn on the switch.
Adjust the volume control knob.
Connect the audio sources correctly.
Turn down the source volume
and the MSS volume.
Replace the batteries with new ones.
7. TROUBLESHOOTING
