Акустика Sven MS-2100 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
ENG
24
•
Adjust the bass and treble level using the
BASS+/-
e
and TREBLE+/-
b
buttons on the re-
mote control.
•
To adjust the subwoofer volume, use the SW+/- buttons
f
on the remote control.
•
To listen to the radio, connect the antenna to the RADIO ANT
k
jack (see Fig. 4) and adjust it for
better reception.
•
After completing the MSS operation, mind to switch it o
ff
using the ON/OFF switch (
i
, OFF
position) and unplug the power cord
j
from the socket.
6. OPERATION MODES
Player Mode
•
The system will automatically enter the Player mode when a USB device is connected to the USB
port
d
or an SD card is inserted into the corresponding slot
c
; or press the INPUT button
h
on
the front panel or the INPUT button
a
on the remote control. The display
a
will show the selected
mode, then the number of the tracks found and the number of the track played, and then the
playback time elapsed. The
fi
les will automatically start playing. The playing device symbol will show
on the display as well.
•
To select a track, you can directly enter its number on the remote control using the numeric pad
buttons
g
or select it using buttons
e
and
g
on the front panel. The display
a
will show the track
number for a short time, and then the playback time elapsed.
•
You can select the playback mode using the remote control REPEAT button
h
(“ONE” – the playing
track replay; “RND” – play random tracks; “ALL” – play all tracks available).
* The MSS operation may be incorrect if an SD card of 512 Mb capacity or lower is used. If a USB
fl
ash device of 8 Gb capacity or more is used, command processing time may be extended.
Tuner Mode
•
To switch to the Tuner mode, use the INPUT button
h
on the front panel or the INPUT button
a
on the remote control. The subwoofer display
a
will show the FM inscription.
•
To auto scan and memorize the found stations, press AUTO button
f
on the front panel or the
AUTO button
n
on the remote control short. To stop auto scanning, press this button again before
the scanning is over. The display
a
will show the frequency being scanned. When the channel is
being memorized, the display shows its number for a short moment.
•
For manual scanning, use buttons TUNE-/+
c
on the remote control (up/down the frequency
range). To save the selected station, press the SAVE button
r
on the remote control and then,
using buttons
e
and
g
on the front panel or buttons
d
and
m
on the remote control, assign the
station its number and press the SAVE button
r
again. When the station has been memorized, the
display
a
will write “Good”.
•
If preset stations are available in the memory, you can switch from one to another by short pressing
buttons
e
,
g
on the front panel or buttons
d
,
m
on the remote control. You can also enter the
frequency or the number of the preset station with the remote control numeric pad buttons. The
display will show the station number for a short moment and then its frequency.
The radio will tune to the set frequency within 2-3 seconds.
AUX/PC Mode
•
To switch to the AUX/PC mode, press the INPUT button
h
on the front panel or the INPUT button
a
on the remote control, the MSS switched on. The display
a
will show AUX or PC inscription.
2.1 Multimedia Speaker System
