Teka DVN 94030 - Инструкция по эксплуатации - Страница 17

17 

paragraph). This/these is/are to be mounted only if you want 
lo use the hood in the filtering version. 

• 

Check (for transport reasons) that there is no other supplied 
material inside the hood (e.g. packets with screws (*), 
guarantees (*), etc.), eventually removing them and keeping 
them. 

  
Expansion wall plugs are provided to secure the hood to most 
types of walls/ceilings. However, a qualified technician must verify 
suitability of the materials in accordance with the type of 
wall/ceiling. The wall/ceiling must be strong enough to take the 
weight of the hood.  

Do not tile, grout or silicone this appliance to the wall. Surface 
mounting only. 

Operation 

  
To select the functions of the hood, simply touch the commands: 
 

a.

  Button to increase suction speed (power):  

Suction speed (power) 1  

Suction speed (power) 2  

Suction speed (power) 3  

b.

  Button to decrease suction speed (power). 

c.

  Button ON/OFF hood 

d.

  Button ON/OFF lighting 

e.

  Button ON/OFF programmed switching off:  

it programs switching off of the active suction speed (power) 
after approximately 3 minutes. 

Maintenance 

Cleaning 

Clean using 

ONLY

 a cloth dampened with neutral liquid detergent. 

DO NOT CLEAN WITH TOOLS OR INSTRUMENTS

. Do not use 

abrasive products. 

DO NOT USE ALCOHOL! 

Grease filter 

Fig. 10-11 
Traps cooking grease particles. 

The grease filter

 must be cleaned once a month using non 

aggressive detergents, either by hand or in the dishwasher, which 
must be set to a low temperature and a short cycle.  When washed 
in a dishwasher, the grease filter may discolor slightly, but this 
does not affect its filtering capacity. 
To remove the grease filter, pull the spring release handle. 

Charcoal filter (filter version only) 

Fig. 12 
It absorbs unpleasant odors caused by cooking. 

The saturation of the 

charcoal filter

 occurs after more or less 

prolonged use, depending on the type of cooking and the regularity 
of cleaning of the grease filter. 
In any case it is necessary to replace the cartridge at least every 
four months. 
The charcoal filter may NOT be washed or regenerated. 

Circular charcoal filter 

Apply one on each side as cover to both the shield grids of the 
motor impeller, then turn clockwise. 
For the disassembly, turn counter-clockwise. 

Replacing lamps 

The hood is equipped with a lighting system based on LED 
technology. 
The LEDs guarantee an optimum lighting, a duration up to 10 
times longer than the traditional lamps and allow to save 90% 
electrical energy. 
 
For replacement, contact the technical service.