Neff D86E34N0 - Инструкция по эксплуатации - Страница 14

14

Prior to installation

Preparing t h e  w a l l

❑

The wall must be flat and perpendicular.

❑

Make sure that the wall can bear the
applied loads.

❑

The provided screws and wall plugs are
suitable for solid masonry. On all other
wall types (e.g. plasterboard, porous
concrete, Poroton bricks) use the
appropriate fasteners.

❑

Ensure that the wall is capable of provi-
ding a firm hold for mounting screws
and plugs.

Electrical connection

WARNING: THIS APPLIANCE MUST BE
EARTHED

IMPORTANT: Fitting a Different Plug:

The wires in the mains lead are coloured in
accordance with the following code:

Green and Yellow

– Earth

Blue

– Neutral

Brown

– Live

Electrical connection

If you fit your own plug, the colours of 
these wires may not correspond with the
identifying marks on the plug terminals.
This is what you have to do:

1.

Connect the green and yellow (Earth) 

wire to the terminal in the plug marked
‘E’ or with the symbol (        ), or 
coloured green or green and yellow.

2.

Connect the blue (Neutral) wire to the 

terminal in the plug marked ‘N’ or 
coloured black.

3.

Connect the brown (Live) wire to the 

terminal marked ‘L’, or coloured red.

The extractor hood 

should only be con-

nected to an earthed socket that has been
installed according to relevant regulations.
If possible, site the earthed socket directly
behind the chimney panelling.

❑

The earthed socket should be 
connected via its own circuit.

❑

If the earthed socket is no longer 
accessible following installation of the
extractor hood, ensure that there is a
permanently installed disconnector.

If it is necessary to wire the extractor
hood directly into the mains:

The extractor hood should only be
connected to the electricity supply by a 
properly qualified electrician.
A separator must be installed in the
household circuit. A suitable separator is a
switch that has a contact gap of more than
3 mm and interrupts all poles. Such devices
include circuit breakers and contactors.

If the connecting cable for this 

appliance is damaged, the cable must be
replaced by the manufacturer or his custo-
mer service or a similarly qualified person in
order to prevent serious injury to the user.

Electrical data:

Are to be found on the name plate inside
the appliance after removal of the filter
frame.

Before undertaking any repairs,

always disconnect the extractor hood from
the electricity supply.

Length of the connecting cable: 1.30 m.

This extractor hood corresponds to EC
regulations concerning RF interference 
suppression.

Weight in kg:

Exhaust air

Recirculating

air

16,5

60 cm

70 cm

18,0

17,2

18,7

90 cm

18,7

20,2

We reserve the right to construction changes within the 
context of technical development.