MONSHER REIMS 50 - Инструкция по эксплуатации - Страница 20

English

20

8. Do not use the appliance without the aluminum filter in place.
9. Do not touch the lamps.
10. Do not remove the aluminum filter while the appliance is in operation.
11. Do not disconnect the appliance from the power supply system directly. If necessary, turn 

the appliance off using the control panel and, only after that, unplug it from the power supply 
system. When switching on: first connect the appliance to the power supply system, then switch 
it on using the control panel, but not vice versa!

12. The appliance requires regular cleaning and maintenance work.
13. When installing the appliance, observe the required distance between it and the cooking 

surface of your stove:

- for an electric stove: at least 60 cm
- for a gas or gas-electric stove: at least 65 cm

14. Do not allow children to play with packaging materials, it can be dangerous!
15. The appliance is allowed to be turned on only once the pots and/or pans are placed on 

the stove.

16. For best air cleaning in your kitchen, do not turn off the appliance immediately after the 

cooking process is completed: let the appliance run for a further 15 minutes. For this purpose 
you can also use the timer function (the button «Auto Switch Off Timer» on the control panel).

17. Ensure adequate ventilation in the kitchen, if a gas stove is operated simultaneously with 

the appliance.

18. In case of any malfunctions, contact your nearest authorized service center.
19. If the kitchen hood is supposed to operate in air discharge mode, then during installation 

it is important to provide a duct of the corresponding diameter. To prevent loss of performance 
caused by aerodynamic resistance of the duct, the air duct must not be too long, or curved. 
Never restrict the duct size, or make sharp bends. In addition, it is preferable to use smooth PVC 
duct (round or flat), rather than the flexible corrugated one because bends of a corrugated duct 
increase the noise level of the hood.

20. The manufacturer does not bear any responsibility for any possible damage, in case of 

non-compliance with above precautions.