Kuppersberg Slimlux IV 60 XGL - Инструкция по эксплуатации - Страница 24

24

TECHNICAL PASSPORT

ENGLISH

Сooker hood

7. INSTRUCTIONS FOR 

USE OF THE COOKER 

HOOD

7.1. The cooker hood with mecha- 

nical switch has 3 speeds of ventilation. 

Depending on the amount of 

evaporation during cooking, you can 

choose a low, medium or high of 

ventilation level.

7.2 Before cooking, turn on the 

hood in the required operating mode. 

It is recommended to continue work of 

the cooker hood for 3-5 minutes after 

cooking, thus the air in the kitchen 

will be cleared from the residue of the 

vapours.

7.3. On the sides of the body there 

is a key switch for operating modes of 

the engine and switching the lighting 

lamps (Fig. 5).

I 

speed (low speed) – press the 

switch to position “I”

II  speed (average speed) – press 

the switch “TURBO” to position “II”

III  speed (high speed) – press the 

switch “TURBO” to position “I” (on the 

speed I and II switch “TURBO” should 

remain in the position 0) 0 – fan is off).

Fig. 5

The key switch with the symbol of 

the light bulb, intended to turn on the 

lamp  at  insufficient  illumination  of  the 

working area of the cooker, is located on 

the left side of body of the cooker hood.

0 – light is off;

II – light is on independently of the 

position of the pull-out panel with the 

filter;

I – light is on when the panel pulled-

out.

8. INSTRUCTIONS TO 

CARE THE COOKER 

HOOD

ATTENTION!

BEFORE CLEANING THE COOKER 

HOOD, DISCONNECT IT FROM THE 

ELECTRIC MAINS.

8.1 For external cleaning of

stainless steel cooker hoods, use 

special means in accordance with the 

relevant instructions.

8.2 Never use abrasive detergents 

and means that contain soda, acid, 

chlorides or solvents, coarse sponges to 

clean the cooker hoods.

8.3 By washing avoid moisture 

entering the current-carrying parts of 

the cooker hood, and especially into the 

electronic control unit; after washing, 

wipe the surface with a soft cloth.

8.4 For cleaning glass surfaces, 

conventional glass cleaning means are 

suitable.