Kuppersberg RAMZ 90 B - Инструкция по эксплуатации - Страница 12

12

ENGLISH

Cooker hood

TECHNICAL PASSPORT

MAINTENANCE

Â

Attention! Before performing any 

maintenance operation, isolate the hood 

from the electrical supply by switching 

off at the connector and removing the 

connector fuse.

Or if the appliance has been 

connected through a plug and socket, 

then the plug must be removed from 

the socket.

CLEANING

The cooker hood should be 

cleaned regularly (at least with the 

same frequency with which you carry 

out  maintenance  of  the  fat  filters) 

internally and externally. Clean using 

the cloth dampened with neutral liquid 

detergent. Do not use abrasive products. 

DO NOT USE ALCOHOL!

Â

Warning: Failure to carry out the 

basic cleaning recommendations of the 

cooker hood and replacement of the 

filters may cause fire risks.

Therefore, we recommend observing 

these instructions.

The manufacturer declines all 

responsibility for any damage to 

the  motor  or  any  fire  damage  linked 

to inappropriate maintenance or 

failure to observe the above safety 

recommendations.

GREASE FILTER

Traps cooking grease particles.

The  grease  filter  must  be  cleaned 

once a month using non aggressive 

detergents, either by hand or in the 

dishwasher, which must be set to a low 
temperature and a short cycle. When 
washed in a dishwasher, the grease 
filter  may  discolour  slightly,  but  this 
does not affect its filtering capacity.

To remove the grease filter, pull the 

spring release handle.

Charcoal filter (filter version only)
It absorbs unpleasant odours caused 

by cooking.

The  saturation  of  the  charcoal  filter 

occurs after more or less prolonged use, 

depending on the type of cooking and 
the regularity of cleaning of the grease 
filter.

In any case it is necessary to 

replace the cartridge at least every four 
mounths.

The  charcoal  filter  may  NOT  be 

washed or regenerated.

CIRCULAR CARBON FILTER

Apply one on each side as cover 

to both the shield grids of the motor 
impeller, then turn clockwise.

For the disassembly, turn counter-

clockwise.

REPLACING LAMPS

The illumination system consists of  

3x3 W LED

Disconnect the appliance from the 

electricity.

Warning! Prior to touching the light 

bulbs ensure they are cooled down.

Replace the old light bulb with the 

one of the same type as specified in the