Kaiser A 501 NG - Инструкция по эксплуатации - Страница 4

4

English

WARNING

------------------------------------------------

The distance between the supporting surface for
the cooking vessels on the hob and the lower
part of the hood must be at least 65 cm. If the
instructions for installation for the hob specify a
greater distance, this has to be taken into account.
The air collected must not be conveyed into a duct
used to blow off smokes from appliances fed with
an energy other than electricity (central heating
systems, thermosiphons, water-heaters, etc.).
Comply with the official instructions provided by
the competent authorities in merit when installing
the disposal duct. In addition, exhaust air should
not be discharged into a wall cavity, unless the
cavity is designed for that purpose.
The room must be well aerated in case a hood
and some other heat equipment fed with an
energy other than electricity (gas, oil, coal heaters,
etc) operate at the same time.
In fact the intake hood, disposing of air, could
create a vacuum in the room. The vacuum
should not exceed 0,04mbar. This prevents the
gas exhausted by the heat source from being
intaken again. It is therefore advisable to ensure
the room contains air taps able to ensure a
steady flow of fresh air.

Check the data label inside the appliance; if
the symbol (   ) is printed, read the following:
this appliance has such technical particulars
that it belongs to class II insulation, therefore
it must not be earthed.

The following warning is valid in the United
Kingdom only: in case your cable is not furnished
with a plug, read the following instructions; as
the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows: – the wire which is coloured
blue must be connected to the terminal which is
marked with the letter N or coloured black; – the
wire which is coloured brown must be connected
to the terminal which is marked with the letter L
or coloured red. – terminal of a three-pin plug.

Check the data label inside the appliance; if
the symbol (   ) is NOT printed, read the
following: ATTENTION: This appliance must
be earthed.

 When making the electrical

connections, check that the current socket has a
ground connection.
The following warning is valid in the United
Kingdom only: in case your cable is not furnished

den Metallpaneelfilter heraus.
Synthetikfilterpaneel (wie in Abb. 15P gezeigt):
dieser aus weißer Synthetikfaser bestehende Filter
befindet sich im Innern des Metallgitters und ist je
nach Benutzung periodisch (wenigstens alle zwei
Monate) zu ersetzen.  Entfernen Sie die 2
F i l t e r h a l t e r   ( M )   u n d   z i e h e n   S i e   d e n
Synthetikpaneelfilter heraus.

K o h l e n f i l t e r

:   d i e   K o h l e f i l t e r   m ü s s e n

regelmäßig, je nach Gebrauch des Geräts mehr
oder weniger häufig ausgetauscht werden
(durchschnittlich alle 6 Monate). Zur Entfernung
der Kohlenfilter (A), Filterhalter M (Abb.8-910).
abnehmen.

Beleuchtung: 

Zum Austausch der Lampen

ist die Deckenleuchte nach Herausnehmen der
Halteschraube “A” (Abb.16)  zu entfernen.
Durch Lampen desselben Typs ersetzen.