Jetair Monica IX/A/60 - Инструкция по эксплуатации - Страница 23

23 

Maintenance 

ATTENTION! 

Before performing any maintenance operation, 

isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend observing these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Grease filter 

Fig. 11-27 
Traps cooking grease particles. 

This must be cleaned once a month (or when the filter 
saturation indication system – if envisaged on the model in 
possession – indicates this necessity)  using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle. 
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
To remove the grease filter, pull the spring release handle. 

Charcoal filter (filter version only) 

Fig. 28 
It absorbs unpleasant odours caused by cooking. 

The charcoal filter can be washed once every two months 
using hot water and a suitable detergent, or in a dishwasher at 
65°C (if the dishwasher is used, select the full cycle function 
and leave dishes out). 

Eliminate excess water without damaging the filter, then put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 
damaged. 
• 

Montage 

Install the carbon filter on the back of the grease filter and 
fix with 4 rods.    

Attention!

 The rods are included in the carbon filter 

packing and not on the hood.   

• 

To dismantle the filter act in the reverse manner. 

Replacing lamps 

Fig. 29 

Disconnect the hood from the electricity. 

Warning! 

Prior to touching the light bulbs ensure they are 

cooled down. 
Replace the old light bulb with the one of the same type as 
specified in the feature label or near the light lamp on the 
hood. 

1.

  Using a flat head screwdriver or equivalent tool, carefully 

pry loose the light cover.   

2.

  Remove the damaged light and replace with a new 12 

Volt, 20 Watt (Maximum) halogen light made for a G-4 
base SUITABLE FOR USE IN OPEN LUMINAIRES.  
Follow package directions and do not touch new light 
with bare hands. 

3.

  Reinstall the light  cover. (it will snap shut). 

If the lights do not work, make sure that the lamps are fitted 
properly into their housings before you call for technical 
assistance. 
 
 

- Model with LED light 

The hood is equipped with a lighting system based on LED 
technology. 
The LEDs guarantee an optimum lighting, a duration up to 10 
times as long as the traditional lamps and allow to save 90% 
electrical energy. 
 
For replacement, contact the technical service.