Jetair Gisela IX/F/50 (PRF0099093) - Инструкция по эксплуатации - Страница 19

19 

Warning! Detail B (fixing bracket to the ceiling - Fig. 1) is 
equipped with a conductor (yellow-green) that must be 
connected to the earth of the domestic electrical plant. 
Fig. 4 

 ATTENTION! 

Be particularly careful about positioning

the excess cable. Failure to observe this indication could 
cause grave damage to the apparatus and/or an electric 
shock to the user or the installer. For further details see 

Fig. 

8-15 
Warining!

 Changing the interconnection cable must be 

carried out by the authorised technical assistance service. 

Mounting 

Expansion wall plugs are provided to secure the hood to most 
types of walls/ceilings. However, a qualified technician must 
verify suitability of the materials in accordance with the type of 
wall/ceiling. The wall/ceiling must be strong enough to take 
the weight of the hood. 

Do not tile, grout or silicone this 

appliance to the wall. Surface mounting only. 

Additional Installation Specifications:  

Use only the fixing screws supplied with the product for 
installation.  
Use the correct length screws which are identified in the 
Installation Guide  

WARNING! 

Failure to install the screws or fixing device in 

accordance with these instructions may result in electrical 
hazards. 

Description of the hood 

Fig. 1 
A. 

Cover

B. 

Support to the ceiling bracket  

C.

  Regulators of the tie-rods of the hood 

D.

 Decorative cover 

E.

  Box for connecting to the domestic power network 

F.

 Interconnection cable 

G.

  Halogen bulb  

H.

  Active carbon filter 

I.

  Metal anti-fat filter  

Operation 

Use the high suction speed in cases of concentrated kitchen 
vapours.  It is recommended that the cooker hood suction is 
switched on for 5 minutes prior to cooking and to leave in 
operation during cooking and for another 15 minutes 
approximately after terminating cooking.  
  

A. 

on/off light switch 

B. 

on/off aspiration switch and minimum power selection 

B+C. 

medium power selection aspiration switch 

B+D. 

maximum power selection aspiration switch 

Maintenance 

ATTENTION! 

Before performing any maintenance operation, 

isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend observing these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Grease filter 

Traps cooking grease particles. 

This must be cleaned once a month (or when the filter 
saturation indication system – if envisaged on the model in 
possession – indicates this necessity)  using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle. 
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity.